The bending stress in a wall or column subjected to effective vertical load need not be considered, if the eccentricity ratio is Options: A . &nbspLess than or equal to 1/24 B . &nbspLess than or equal to 1/6 C . &nbspMore than 1/24 D . &nbspLess than or equal to 1/12

The bending stress in a wall or column subjected to effective vertical load need

Question

The bending stress in a wall or column subjected to effective vertical load need not be considered, if the eccentricity ratio is

Options:

A . Less than or equal to 1/24

B . Less than or equal to 1/6

C . More than 1/24

D . Less than or equal to 1/12

Answer: Option A

Submit Your Solution Below and Earn Points !

Next Question

Question 1. Assertion A : Lime based mortars give higher ratio of brickwork strength to mortar strength as compared to non-lime mort....non-lime mortars.Select your answer according to the codes given below:

Question 2. Assertion A : From consideration of structural soundness and economy of design, most codes control the maximum slenderne....by buckling. Select your answer according to codes given below:

Question 3. Assertion A : Limiting value of slenderness ratio for a column is less than that of a wall.Reason R : A column can buckl....one axis.Select your answer according to the codes given below:

Question 4. The effective height of free standing non-load bearing wall and column respectively will be....

Question 5. Consider the following statements: The use of relatively weak mortar 1. Will accommodate movements due to loads and, cra....reduction of stresses due to differential expansion of masonry units.

Question 6. Rich cement mortars are more liable to cracking as compared to lean mortars because rich mortars have....

Question 7. For masonry built in 1 : 1 : 6 cement-lime-sand mix mortar or equivalent, the horizontal shear stress permissible on the....permissible on the area of a mortar bed joint is

Question 8. Direct load carrying capacity of a brick masonry wall standing freely as against when it supports RC slab will be....

Question 9. Maximum slenderness ratio of load bearing walls for a dwelling having more than 2 storeys(i) Shall not exceed 12 if lime....exceed 24 if cement mortar 1 : 6 is used

Question 10. The timber floor not spanning on the masonry wall but properly anchored to the wall gives....

Chapter 1 - GLOBAL STEEL SCENARIO & INDIAN STEEL INDUSTRY Part 1 : (13-04-2024) INDUSTRY AND COMPANY AWARENESS (ICA)

Direction Sense Test Part 1 Reasoning (Hindi)

Chapter 1 - RMHP / OHP / OB & BP Part 1 : (14-02-2024) GPOE

Cube & Cuboid Part 1 Reasoning (Hindi)

Data Interpretation (DI) Basic Concept Reasoning (Hindi)

Counting Figures Part 1 Counting Of Straight Lines Reasoning (Hindi)

Sail E0 free webinar Webinars

Real Numbers Part 7 Class 10 Maths

Real Numbers Part 1 Class 10 Maths

Polynomials Part 1 Class 10 Maths

DSP Combined 1 Free Revision Test SAIL JO E-0

GPOE / GPA Combined 1 Free Revision Test SAIL JO E-0

BSP Plant Specific Review Test SAIL JO E-0

BSL Combined 1 Free Revision Test SAIL JO E-0

GFM Combined 1 Free Revision Test SAIL JO E-0