Direct load carrying capacity of a brick masonry wall standing freely as against

Question

Direct load carrying capacity of a brick masonry wall standing freely as against when it supports RC slab will be

Options:

A . More

B . Less

C . The same in both the cases

D . 100 %

Answer: Option B

Submit Your Solution Below and Earn Points !

Next Question

More Questions on This Topic :

Question 1. Maximum slenderness ratio of load bearing walls for a dwelling having more than 2 storeys(i) Shall not exceed 12 if lime....exceed 24 if cement mortar 1 : 6 is used

Question 2. The timber floor not spanning on the masonry wall but properly anchored to the wall gives....

Question 3. Assertion A : For identical strength, a composite cement-lime mortar is preferred over cement mortar.Reason R : Composit....mortar.Select your answer based on the codes given below. Codes:

Question 4. For earthquake resistant masonry buildings, the vertical distance between openings one above the other in a load bearing....in a load bearing wall shall not be less than

Question 5. For earthquake resistant masonry buildings, where seismic coefficient is less than 0.08, the horizontal distance between....horizontal distance between two openings shall not be less than

Question 6. Consider the following statements:A high lime content in a composite cement-lime mortar results in1. Slow hardening.2. Q....cement-lime mortar results in1. Slow hardening.2. Quick setting.3. Weaker mortar.

Question 7. Full restraint is provided by(i) Foundation footing of a wall(ii) Timber floor spanning on the wall and anchored to the ....with a minimum bearing of 10 cm on the wall

Question 8. In the case of panel wall subjected to horizontal loads at right angles to the plane of the wall, with the mortar not le....the vertical direction may be allowed to the extent of

Question 9. For strengthening a 50 m long and 5 m high straight compound wall built in brick work, which one of the following would ....work, which one of the following would be most suitable?

Question 10. The basic stress in masonry units having height to width ratio of 1.5 may be increased by a factor of....

Chapter 1 - GLOBAL STEEL SCENARIO & INDIAN STEEL INDUSTRY Part 1 : (13-04-2024) INDUSTRY AND COMPANY AWARENESS (ICA)

Direction Sense Test Part 1 Reasoning (Hindi)

Chapter 1 - RMHP / OHP / OB & BP Part 1 : (14-02-2024) GPOE

Cube & Cuboid Part 1 Reasoning (Hindi)

Data Interpretation (DI) Basic Concept Reasoning (Hindi)

Counting Figures Part 1 Counting Of Straight Lines Reasoning (Hindi)

Sail E0 free webinar Webinars

Real Numbers Part 7 Class 10 Maths

Real Numbers Part 1 Class 10 Maths

Polynomials Part 1 Class 10 Maths

DSP Combined 1 Free Revision Test SAIL JO E-0

GPOE / GPA Combined 1 Free Revision Test SAIL JO E-0

BSP Plant Specific Review Test SAIL JO E-0

BSL Combined 1 Free Revision Test SAIL JO E-0

GFM Combined 1 Free Revision Test SAIL JO E-0