Sail E0 Webinar

MCQs

Total Questions : 1342 | Page 131 of 135 pages
Question 1301. A valve which maintains a constant degree of superheat at the end of the evaporator coil, is called
  1.    Automatic expansion valve
  2.    Thermostatic expansion valve
  3.    High side float valve
  4.    Low side float valve
 Discuss Question
Answer: Option D. -> Low side float valve
Question 1302. Absorption system normally uses the following refrigerant
  1.    Freon-11
  2.    CO2
  3.    Freon-22
  4.    Ammonia
 Discuss Question
Answer: Option D. -> Ammonia
Question 1303. The pressure at the outlet of a refrigerant compressor is called
  1.    Discharge pressure
  2.    Suction pressure
  3.    Critical pressure
  4.    Back pressure
 Discuss Question
Answer: Option A. -> Discharge pressure
Question 1304. The coefficient of performance of Electrolux refrigerator is the ratio of
  1.    Heat supplied by the gas burner minus the heat absorbed by the evaporator to the heat supplied by the gas burner
  2.    Heat supplied by the gas burner to the heat absorbed by the evaporator
  3.    Heat absorbed by the evaporator to the heat supplied by the gas burner
  4.    Heat absorbed by the evaporator minus the heat supplied by the gas burner to the heat absorbed by the evaporator
 Discuss Question
Answer: Option C. -> Heat absorbed by the evaporator to the heat supplied by the gas burner
Question 1305. In a saturated air-water vapour mixture, the
  1.    Dry bulb, wet bulb and dew point temperature are same
  2.    Dry bulb temperature is higher than dew point temperature
  3.    Dry bulb temperature is higher than wet bulb temperature
  4.    Dew point temperature is lower than wet bulb temperature
 Discuss Question
Answer: Option A. -> Dry bulb, wet bulb and dew point temperature are same
Question 1306. One of the purposes of sub cooling the liquid refrigerant is to
  1.    Ensure that only liquid and not the vapour enters the expansion (throttling) valve
  2.    Increase cooling effect
  3.    Reduce compressor overheating
  4.    Reduce compressor discharge temperature
 Discuss Question
Answer: Option A. -> Ensure that only liquid and not the vapour enters the expansion (throttling) valve
Question 1307. The refrigerant for a refrigerator should have
  1.    Low latent heat
  2.    High latent heat
  3.    High total heat
  4.    High sensible heat
 Discuss Question
Answer: Option B. -> High latent heat
Question 1308. It is desired to condition the outside air from 70% relative humidity and 45° C dry bulb temperature to 50% relative humidity and 25° C dry bulb temperature (room condition). The practical arrangement will be
  1.    Cooling and dehumidification
  2.    Cooling and humidification
  3.    Dehumidification and pure sensible cooling
  4.    Dehumidification
 Discuss Question
Answer: Option A. -> Cooling and dehumidification
Question 1309. During dehumidification process, _________ remains constant.
  1.    Dry bulb temperature
  2.    Wet bulb temperature
  3.    Specific humidity
  4.    Relative humidity
 Discuss Question
Answer: Option A. -> Dry bulb temperature
Question 1310. The difference between dry bulb temperature and wet bulb temperature, is called
  1.    Wet bulb depression
  2.    Dry bulb depression
  3.    Dew point depression
  4.    Degree of saturation
 Discuss Question
Answer: Option A. -> Wet bulb depression

Latest Videos

Latest Test Papers