Sail E0 Webinar

MCQs

Total Questions : 1124 | Page 46 of 113 pages
Question 451.

 
In nuclear power plants, due to reflector, less fuel is needed to generate sufficient neutrons to sustain a chain reaction.


  1.    Yes
  2.    No
 Discuss Question
Answer: Option A. -> Yes


Question 452.

 
The nuclear power station at Tarapur has the reactor of the __________ type.


  1.    pressurized water
  2.    boiling water
  3.    gas cooled
  4.    liquid metal cooled
 Discuss Question
Answer: Option B. -> boiling water


Question 453.


High speed compression engines operate on


  1.    Otto cycle
  2.    Diesel cycle
  3.    Dual-combustion cycle
  4.    all of these
 Discuss Question
Answer: Option C. -> Dual-combustion cycle


Question 454.


In a four stroke cycle petrol engine, the inlet valve


  1.    opens at top dead centre and closes at bottom dead centre
  2.    opens at `20^circ` before top dead centre and closes at `40^circ`after bottom dead centre
  3.    opens at `20^circ` after top dead centre and closes at `20^circ` before bottom dead centre id) may open or close anywhere
 Discuss Question
Answer: Option B. -> opens at `20^circ` before top dead centre and closes at `40^circ`after bottom dead centre


Question 455.

The injection pressure in a diesel engine is about


  1.    10 bar
  2.    100 bar
  3.    150 bar
  4.    500 bar
 Discuss Question
Answer: Option B. -> 100 bar


Question 456.

he thermal efficiency of diesel engines on weak mixtures is


  1.    unaffected
  2.    lower
  3.    higher
  4.    dependent on other factors
 Discuss Question
Answer: Option C. -> higher


Question 457.


In a four stroke
cycle petrol engine, the charge is compressed when both the valves
(i.e. inlet valve and exit valve) are closed,


  1.    Agree
  2.    Disagree
 Discuss Question
Answer: Option A. -> Agree


Question 458.


Morse test can be conducted for


  1.    petrol engines
  2.    diesel engines
  3.    multi-cylinder engines
  4.    all of these
 Discuss Question
Answer: Option C. -> multi-cylinder engines


Question 459.

 
The basic requirement of a good combustion chamber is


  1.    minimum turbulence
  2.    low compression ratio
  3.    high thermal efficiency and power output
  4.    low volumetric efficiency
 Discuss Question
Answer: Option C. -> high thermal efficiency and power output


Question 460.


The pre-ignition occurs before the spark is produced whereas detonation develops after the introduction of spark.


  1.    Agree
  2.    Disagree
 Discuss Question
Answer: Option A. -> Agree


Latest Videos

Latest Test Papers