Questions and answers for exam Preparation

MCQs

Total Questions : 364 | Page 36 of 37 pages

Question 351. Which of the following instruments is used to measure base pitch of a gear in base tangent method?

Gear tooth vernier caliper
David Brown tangent caliper
David Brown tangent comparator
David Brown tangent micrometer

Discuss Question

Answer: Option C. -> David Brown tangent comparator
NO EXPLANATION IS AVAILABLE FOR THIS QUESTION!

Question 352. Which of the following components are inspected by a Tool maker's microscope?

gauges
screw threads
dies and fixtures
all of the above

Discuss Question

Answer: Option D. -> all of the above
NO EXPLANATION IS AVAILABLE FOR THIS QUESTION!

Question 353. Which dimensions can be measured using image shearing microscope?

linear dimensions
angular dimensions
both linear and angular dimensions
none of the above

Discuss Question

Answer: Option A. -> linear dimensions
NO EXPLANATION IS AVAILABLE FOR THIS QUESTION!

Question 354. Which among the following is used to measure velocity of an object?

Laser Doppler effect
Laser interferometers
Laser telemetric system
None of the above

Discuss Question

Answer: Option A. -> Laser Doppler effect
NO EXPLANATION IS AVAILABLE FOR THIS QUESTION!

Question 355. Which of the following statements is/are true for sampling inspection?

Acceptance sampling does not involve any risk
Characteristics of the entire lot can be truly specified
Less fatigue results in less mistakes
All the above statements are true

Discuss Question

Answer: Option C. -> Less fatigue results in less mistakes
NO EXPLANATION IS AVAILABLE FOR THIS QUESTION!

Question 356. Which of the following statements is/are true according to Deming's Deadly Diseases?

short term profits are very useful for long term goals
mobility of management leads to stability
merit rating leads to devastating
all of the above

Discuss Question

Answer: Option C. -> merit rating leads to devastating
NO EXPLANATION IS AVAILABLE FOR THIS QUESTION!

Question 357. What is meant by P, D, S and A in PDSA cycle?

Progress Development Study Act
Plan Do Study Act
Project Development Study Act
Prevention Do Study Act

Discuss Question

Answer: Option B. -> Plan Do Study Act
NO EXPLANATION IS AVAILABLE FOR THIS QUESTION!

Question 358. What is capability ratio?

The ratio of process capability and number of units inspected
The ratio of specification range and process capability
The ratio of number of defectives and process capability
The ratio of number of defectives and number of units inspected

Discuss Question

Answer: Option B. -> The ratio of specification range and process capability
NO EXPLANATION IS AVAILABLE FOR THIS QUESTION!

Question 359. What is acceptance quality level?

Maximum percentage of defective parts for sampling purpose are considered satisfactory as a process average
Minimum percentage of defective parts for sampling purpose are considered satisfactory as a process average
Both A & B
None of these

Discuss Question

Answer: Option A. -> Maximum percentage of defective parts for sampling purpose are considered satisfactory as a process average
NO EXPLANATION IS AVAILABLE FOR THIS QUESTION!

Question 360. The aim of Just-In-Time manufacturing principle is to eliminate