Question 821. A network administrator needs to configure a router with a distance-vector protocol that allows classless routing. Which of the following satisfies those requirements?

Question 822. Your company is running IGRP using an AS of 10. You want to configure EIGRP on the network but want to migrate slowly to EIGRP and don't want to configure redistribution. What command would allow you to migrate over time to EIGRP without configuring redistribution?

Question 823. Which command will display all the EIGRP feasible successor routes known to a router?

Question 824. What is the administrative distance of OSPF?

Question 825. What are reasons for creating OSPF in a hierarchical design?1. To decrease routing overhead2. To speed up convergence3. To confine network instability to single areas of the network4. To make configuring OSPF easier

Question 826. Which EIGRP information is held in RAM and maintained through the use of Hello and update packets?1. Neighbor table2. STP table3. Topology table4. DUAL table

Question 827. Which two of the following commands will place network 10.2.3.0/24 into area 0?1. router eigrp 102. router ospf 103. network 10.0.0.04. network 10.2.3.0 0.0.0.255 area05. network 10.2.3.0 0.0.0.255 area 0

Question 828. Which of the following are true regarding OSPF areas?1. You must have separate loopback interfaces configured in each area.2. The numbers you can assign an area go up to 65,535.3. The backbone area is also called area 0.4. If your design is hierarchical, then you don't need multiple areas.5. All areas must connect to area 0.

Question 829. Which is true regarding EIGRP successor routes?1. A successor route is used by EIGRP to forward traffic to a destination.2. Successor routes are saved in the topology table to be used if the primary route fails.3. Successor routes are flagged as "active" in the routing table.4. A successor route may be backed up by a feasible successor route.5. Successor routes are stored in the neighbor table following the discovery process.

Question 830. If routers in a single area are configured with the same priority value, what value does a router use for the OSPF Router ID in the absence of a loopback interface?