Questions and answers for exam Preparation

MCQs

Total Questions : 885 | Page 84 of 89 pages

Question 831. Which of the following network types have a designated router and a backup designated router assigned?1. Broadcast2. Point-to-point3. NBMA4. NBMA point-to-point

All of these
1 and 3
3 and 4
1, 2 and 3

Discuss Question

Answer: Option B. -> 1 and 3

Question 832. Which of the following protocols support VLSM, summarization, and discontiguous networking?1. RIPv12. IGRP3. EIGRP4. OSPF5. BGP6. RIPv2

1 and 4
2 and 5
All of these
3, 4 and 6

Discuss Question

Answer: Option D. -> 3, 4 and 6

Question 833. Which type of OSPF network will elect a backup designated router?1. Broadcast multi-access2. Non-broadcast multi-access3. Point-to-point4. Broadcast multipoint

3 and 4
None of these
1 and 2
3 only

Discuss Question

Answer: Option C. -> 1 and 2

Question 834. You get a call from a network administrator who tells you that he typed the following into his router:Router (config) #router ospf 1Router (config-router) #network 10.0.0.0 255.0.0.0 area 0He tells you he still can't see any routes in the routing table. What configuration error did the administrator make?

The wildcard mask is incorrect.
The OSPF Process ID is incorrect.
The AS configuration is wrong.
The OSPF area is wrong.

Discuss Question

Answer: Option A. -> The wildcard mask is incorrect.

Question 835. You need the IP address of the devices with which the router has established an adjacency. Also, the retransmit interval and the queue counts for the adjacent routers need to be checked. What command will display the required information?

show ip eigrp topology
show ip eigrp interfaces
show ip eigrp adjacency
show ip eigrp neighbors

Discuss Question

Answer: Option D. -> show ip eigrp neighbors

Question 836. Which protocol reduces administrative overhead in a switched network by allowing the configuration of a new VLAN to be distributed to all the switches in a domain?

DHCP
ISL
VTP
STP

Discuss Question

Answer: Option C. -> VTP

Question 837. Which of the following is true regarding VLANs?

VTP is used to send VLAN information to switches in a configured VTP domain.
You should not have more than 10 switches in the same VTP domain.
All VLANs are configured at the fastest switch and, by default, propagate this information to all other switches.
You must have at least two VLANs defined in every Cisco switched network.

Discuss Question

Answer: Option A. -> VTP is used to send VLAN information to switches in a configured VTP domain.

Question 838. Which of the following is true regarding VTP?

All switches are VTP servers by default.
All switches are VTP clients by default.
VTP is on by default with a domain name of Cisco on all Cisco switches.
All switches are VTP transparent by default.

Discuss Question

Answer: Option A. -> All switches are VTP servers by default.

Question 839. Which of the following network types have a designated router and a backup designated router assigned? 1. Broadcast 2. Point-to-point 3. NBMA 4. NBMA point-to-point