MCQs
Total Questions : 152
| Page 7 of 16 pages
Answer: Option A. -> a
Answer: (a).a
Answer: (a).a
Answer: Option A. -> Ogee Fall
Answer: (a).Ogee Fall
Answer: (a).Ogee Fall
Question 63. Consider the following statements.
I. Possibility of combining some other structure with a fall eg. regulator, road bridge etc.
II. Cutting and filling are required below and above the fall should not be necessarily equal.
III. The command should not be reduced due to the lowering of F.S.L and the fall may be located below the outlets.
Which of the following statement is correct for site selection of a fall?
I. Possibility of combining some other structure with a fall eg. regulator, road bridge etc.
II. Cutting and filling are required below and above the fall should not be necessarily equal.
III. The command should not be reduced due to the lowering of F.S.L and the fall may be located below the outlets.
Which of the following statement is correct for site selection of a fall?
Answer: Option D. -> I and III
Answer: (d).I and III
Answer: (d).I and III
Answer: Option A. -> V₁ = 3.44 m/sec and V₃ = 2.54 m/sec
Answer: (a).V₁ = 3.44 m/sec and V₃ = 2.54 m/sec
Answer: (a).V₁ = 3.44 m/sec and V₃ = 2.54 m/sec
Answer: Option A. -> 2.53 m
Answer: (a).2.53 m
Answer: (a).2.53 m
Answer: Option D. -> Well-type fall
Answer: (d).Well-type fall
Answer: (d).Well-type fall
Question 67. Consider the following statements.
I. Syphon falls are commonly used where high levelled small drains do out-fall into a low levelled bigger drain.
II. The D/s well is necessary in case of falls greater than 1.8 m and for discharges greater than 0.29 cumecs.
III. The design discharge is determined based on the fact that V-notch is used.
Which of the following statement is correct?
I. Syphon falls are commonly used where high levelled small drains do out-fall into a low levelled bigger drain.
II. The D/s well is necessary in case of falls greater than 1.8 m and for discharges greater than 0.29 cumecs.
III. The design discharge is determined based on the fact that V-notch is used.
Which of the following statement is correct?
Answer: Option C. -> I and II
Answer: (c).I and II
Answer: (c).I and II
Answer: Option D. -> Loss due to contraction of section
Answer: (d).Loss due to contraction of section
Answer: (d).Loss due to contraction of section
Answer: Option A. -> 1.575 m
Answer: (a).1.575 m
Answer: (a).1.575 m
Answer: Option D. -> 2.22H^3/2 [L + 0.4nH]
Answer: (d).2.22H^3/2 [L + 0.4nH]
Answer: (d).2.22H^3/2 [L + 0.4nH]