You copy a configuration from a network host to a router's RAM. The configuration looks correct, yet it is not working at all. What could the problem be? Options: A . &nbspYou copied the wrong configuration into RAM. B . &nbspYou copied the configuration into flash memory instead. C . &nbspThe copy did not override the shutdown command in running-config. D . &nbspThe IOS became corrupted after the copy command was initiated.

You copy a configuration from a network host to a router's RAM. The configuratio

Question

You copy a configuration from a network host to a router's RAM. The configuration looks correct, yet it is not working at all. What could the problem be?

Options:

A . You copied the wrong configuration into RAM.

B . You copied the configuration into flash memory instead.

C . The copy did not override the shutdown command in running-config.

D . The IOS became corrupted after the copy command was initiated.

Answer: Option C

Submit Your Solution Below and Earn Points !

Next Question

Submit Solution

More Questions on This Topic :

Question 1. A network administrator wants to upgrade the IOS of a router without removing the image currently installed. What comman....room available to hold both the current and new images?

Question 2. You have your laptop directly connected into a router's Ethernet port. Which of the following are among the requir....command must be supplied the IP address of the laptop.

Question 3. Which three commands can be used to check LAN connectivity problems on a router? 1. show interfaces 2. show ....router? 1. show interfaces 2. show ip route 3. tracert 4. ping 5. dns lookups

Question 4. Which command loads a new version of the Cisco IOS into a router?....

Question 5. You are unsuccessful in telnetting into a remote device. What could the problem be? 1. IP addresses are inco....is a defective serial cable. 4. The VTY password is missing.

Question 6. If you want to have more than one Telnet session open at the same time, what keystroke combination would you use?....at the same time, what keystroke combination would you use?

Question 7. What information is displayed by the show hosts command? 1. Temporary DNS entries 2. The names of the router....a host has been connected to the router via Telnet

Question 8. Which command will copy the IOS to a backup host on your network?....

Question 9. You are troubleshooting a connectivity problem in your corporate network and want to isolate the problem. You susp....at fault. What IOS user exec command should you issue?

Question 10. . What should the configuration register value be after you successfully complete the password recovery procedure a....password recovery procedure and return the router to normal operation?

Chapter 1 - GLOBAL STEEL SCENARIO & INDIAN STEEL INDUSTRY Part 1 : (13-04-2024) INDUSTRY AND COMPANY AWARENESS (ICA)

Direction Sense Test Part 1 Reasoning (Hindi)

Chapter 1 - RMHP / OHP / OB & BP Part 1 : (14-02-2024) GPOE

Cube & Cuboid Part 1 Reasoning (Hindi)

Data Interpretation (DI) Basic Concept Reasoning (Hindi)

Counting Figures Part 1 Counting Of Straight Lines Reasoning (Hindi)

Sail E0 free webinar Webinars

Real Numbers Part 7 Class 10 Maths

Real Numbers Part 1 Class 10 Maths

Polynomials Part 1 Class 10 Maths

DSP Combined 1 Free Revision Test SAIL JO E-0

GPOE / GPA Combined 1 Free Revision Test SAIL JO E-0

BSP Plant Specific Review Test SAIL JO E-0

BSL Combined 1 Free Revision Test SAIL JO E-0

GFM Combined 1 Free Revision Test SAIL JO E-0

Submit Solution

More Questions on This Topic :

Latest Videos

Latest Test Papers