Maximum size reduction in a ball mill is done by the, __________ action. Options: A . &nbspattrition B . &nbspcompression C . &nbspimpact D . &nbspcutting

Maximum size reduction in a ball mill is done by the, _________

Question

Maximum size reduction in a ball mill is done by the, __________ action.

Options:

A . attrition

B . compression

C . impact

D . cutting

Answer: Option C
Answer: (c).impact

Was this answer helpful ?

Next Question

Question 1. The power number for a stirred tank becomes constant at high Reynolds number. In this limit, the variation of power inpu....power input with impeller rotational speed (N) is proportional to

Question 2. Rpm of a trommel at critical speed is given by (where, D = Diameter of trommel in ft)....

Question 3. Critical speed of rotation, N (in rps - rotation per second) of a trammel is equal to (where, g = acceleration due to gr....9.81 m/sec² and, r = radius of trammel, metre. )

Question 4. The basic filtration equation is given as in the below figure, where, V is volume of the filtrate ; A is the filtration ....? Neglect filter medium resistance, Rm ; assume incompressible cake.

Question 5. Half the angle of nip, (α), for a roll crusher is given by (where, dr, dp and df are diameters of crushing rolls, feed ....diameters of crushing rolls, feed particles and rolls gap respectively).

Question 6. A centrifugal filtration unit operating at a rotational speed of w has inner surface of the liquid (density ρL) located....cake is formed. The initial pressure drop during filtration is

Question 7. Flow of filtrate through the cake in a plate and frame filter press is best described by the __________ equation.....

Question 8. Bond crushing law....

Question 9. Vacuum is applied in __________ zone, in case of a general type continuous rotary drum vacuum filter.....

Question 10. Capacity (in tons/hr) of jaw/gyratory crusher is equal to (where, L = length of the receiving opening, cm S = greater wi....cm S = greater width of the discharge opening, cm)

Chapter 1 - GLOBAL STEEL SCENARIO & INDIAN STEEL INDUSTRY Part 1 : (13-04-2024) INDUSTRY AND COMPANY AWARENESS (ICA)

Direction Sense Test Part 1 Reasoning (Hindi)

Chapter 1 - RMHP / OHP / OB & BP Part 1 : (14-02-2024) GPOE

Cube & Cuboid Part 1 Reasoning (Hindi)

Data Interpretation (DI) Basic Concept Reasoning (Hindi)

Counting Figures Part 1 Counting Of Straight Lines Reasoning (Hindi)

Sail E0 free webinar Webinars

Real Numbers Part 7 Class 10 Maths

Real Numbers Part 1 Class 10 Maths

Polynomials Part 1 Class 10 Maths

DSP Combined 1 Free Revision Test SAIL JO E-0

GPOE / GPA Combined 1 Free Revision Test SAIL JO E-0

BSP Plant Specific Review Test SAIL JO E-0

BSL Combined 1 Free Revision Test SAIL JO E-0

GFM Combined 1 Free Revision Test SAIL JO E-0