In gears, interference takes place when Options: A . &nbspThe tip of a tooth of a mating gear digs into the portion between base and root circles B . &nbspGears do not move smoothly in the absence of lubrication C . &nbspPitch of the gears is not same D . &nbspGear teeth are undercut

In gears, interference takes place when

Question

In gears, interference takes place when

Options:

A . The tip of a tooth of a mating gear digs into the portion between base and root circles

B . Gears do not move smoothly in the absence of lubrication

C . Pitch of the gears is not same

D . Gear teeth are undercut

Answer: Option A

Submit Your Solution Below and Earn Points !

Next Question

Question 1. If ω/ωn is very high for a body vibrating under steady state vibrations, the phase angle for all values of damping fac....for all values of damping factors, will tend to approach

Question 2. If ω/ωn is very low for a body vibrating under steady state vibrations, the phase angle for all values of damping fact....for all values of damping factors, will tend to approach

Question 3. A typewriter mechanism has 7 numbers of binary joints, six links and none of higher pairs. The mechanism is....

Question 4. A reed type tachometer use the principle of....

Question 5. The velocity of sliding of meshing gear teeth is (Where ω₁ and ω₂ are angular velocities of meshing gears and ‘y....is distance between point of contact and the pitch point)

Question 6. Sensitiveness of the governor is defined as the ratio of the....

Question 7. The direction of linear velocity of any point on a link with respect to another point on the same link is....

Question 8. In a steam engine, one method of obtaining the earlier cut-off with a simple slide valve is by increasing the angle of a....lap and exhaust lap are kept constant. This method will

Question 9. In a steam engine, the earlier cut-off with a simple slide valve may be obtained by increasing the steam lap and the ang....the travel and lead of the valve, this method will

Question 10. Higher pairs are those which have....

Chapter 1 - GLOBAL STEEL SCENARIO & INDIAN STEEL INDUSTRY Part 1 : (13-04-2024) INDUSTRY AND COMPANY AWARENESS (ICA)

Direction Sense Test Part 1 Reasoning (Hindi)

Chapter 1 - RMHP / OHP / OB & BP Part 1 : (14-02-2024) GPOE

Cube & Cuboid Part 1 Reasoning (Hindi)

Data Interpretation (DI) Basic Concept Reasoning (Hindi)

Counting Figures Part 1 Counting Of Straight Lines Reasoning (Hindi)

Sail E0 free webinar Webinars

Real Numbers Part 7 Class 10 Maths

Real Numbers Part 1 Class 10 Maths

Polynomials Part 1 Class 10 Maths

DSP Combined 1 Free Revision Test SAIL JO E-0

GPOE / GPA Combined 1 Free Revision Test SAIL JO E-0

BSP Plant Specific Review Test SAIL JO E-0

BSL Combined 1 Free Revision Test SAIL JO E-0

GFM Combined 1 Free Revision Test SAIL JO E-0