For the taxiways, the following statement is true Options: A . &nbspThe permissible transverse grade is 1.5% B . &nbspAll listed here C . &nbspThe maximum longitudinal grade is 3% D . &nbspThe permissible rate of change of grade is 1%

For the taxiways, the following statement is true

Question

For the taxiways, the following statement is true

Options:

A . The permissible transverse grade is 1.5%

B . All listed here

C . The maximum longitudinal grade is 3%

D . The permissible rate of change of grade is 1%

Answer: Option B

Submit Your Solution Below and Earn Points !

Next Question

Question 1. Assertion A : The ratio of arriving and departing aircrafts influences the airport capacity: Reason R : Landing operatio....Select your answer based on the coding system given below:

Question 2. Assertion A : Airport capacity during IFR conditions is usually less than that during VFR conditions.Reason R: During cl....conditions.Select your answer based on the coding system given below:

Question 3. The minimum width of clearway is....

Question 4. The capacity of parallel runway pattern depends upon....

Question 5. If the width of the approach area near the runway end is 150 m, the width of the approach area at a distance of 3 kilome....a distance of 3 kilometers from runway end will be

Question 6. The maximum value of the angle of turning of the nose gear large jet aircrafts, is limited to....

Question 7. For determining the basic runway length, the landing case requires that aircraft should come to a stop within p % of the....% of the landing distance. The value of p is

Question 8. In an airport, if 4 groups of 5 gates each located well separated are considered for traffic and the future to present t....3, then the total requirement of future gates will be

Question 9. Beaufort scale is used to determine....

Question 10. Which of the following factors are taken into account for estimating the runway length required for aircraft landing?1. ....gradientSelect the correct answer using the codes given below Codes:

Chapter 1 - GLOBAL STEEL SCENARIO & INDIAN STEEL INDUSTRY Part 1 : (13-04-2024) INDUSTRY AND COMPANY AWARENESS (ICA)

Direction Sense Test Part 1 Reasoning (Hindi)

Chapter 1 - RMHP / OHP / OB & BP Part 1 : (14-02-2024) GPOE

Cube & Cuboid Part 1 Reasoning (Hindi)

Data Interpretation (DI) Basic Concept Reasoning (Hindi)

Counting Figures Part 1 Counting Of Straight Lines Reasoning (Hindi)

Sail E0 free webinar Webinars

Real Numbers Part 7 Class 10 Maths

Real Numbers Part 1 Class 10 Maths

Polynomials Part 1 Class 10 Maths

DSP Combined 1 Free Revision Test SAIL JO E-0

GPOE / GPA Combined 1 Free Revision Test SAIL JO E-0

BSP Plant Specific Review Test SAIL JO E-0

BSL Combined 1 Free Revision Test SAIL JO E-0

GFM Combined 1 Free Revision Test SAIL JO E-0