For evaporators and condensers, for the given conditions, the logarithmic mean temperature difference for parallel flow is Options: A . &nbspDoes not depend on counter flow B . &nbspSmaller than counter flow C . &nbspGreater than counter flow D . &nbspEqual to counter flow

For evaporators and condensers, for the given conditions, the logarithmic mean t

Question

For evaporators and condensers, for the given conditions, the logarithmic mean temperature difference for parallel flow is

Options:

A . Does not depend on counter flow

B . Smaller than counter flow

C . Greater than counter flow

D . Equal to counter flow

Answer: Option D
Answer: (d).Equal to counter flow

Was this answer helpful ?

Next Question

Question 1. Pick the odd one out.....

Question 2. A cross flow type air heater has an area of 50 cm². The overall heat transfer coefficient is 100 W/m² K and he....stream is 1000 W/m K. The value of NTU is

Question 3. Water (specific heat = 4 k J/kg K) enters a cross flow exchanger (both fluids unmixed) at 15 degree Celsius and flows at....and the surface area is 240 m², determine the NTU

Question 4. After expansion from a gas turbine, the hot exhaust gases are used to heat the compressed air from a compressor with the....is the number of transfer units of the heat exchanger?

Question 5. E – NTU method is particularly useful in thermal design of heat exchangers when....

Question 6. The engine oil at 150 degree Celsius is cooled to 80 degree Celsius in a parallel flow heat exchanger by water entering ....at 60 degree Celsius. Estimate the number of transfer units

Question 7. In a surface condenser, the water flowing through a series of tubes at the rate of 200 kg/hr is heated from 15 degree Ce....Take specific heat of water as 4 k J/kg K

Question 8. When two fluids of the heat exchanger are separated by a plane wall, the thermal resistance comprises (i) Convection res....the fluid film at the outside surface Identify the correct option

Question 9. NTU is a number of transfer units, dimensionless parameter defined as....

Question 10. Figure represents the block diagram of a heat exchanger. There were some aspects in the design and performance analysis ....performance analysis of a heat exchanger. Identify the correct one

Chapter 1 - GLOBAL STEEL SCENARIO & INDIAN STEEL INDUSTRY Part 1 : (13-04-2024) INDUSTRY AND COMPANY AWARENESS (ICA)

Direction Sense Test Part 1 Reasoning (Hindi)

Chapter 1 - RMHP / OHP / OB & BP Part 1 : (14-02-2024) GPOE

Cube & Cuboid Part 1 Reasoning (Hindi)

Data Interpretation (DI) Basic Concept Reasoning (Hindi)

Counting Figures Part 1 Counting Of Straight Lines Reasoning (Hindi)

Sail E0 free webinar Webinars

Real Numbers Part 7 Class 10 Maths

Real Numbers Part 1 Class 10 Maths

Polynomials Part 1 Class 10 Maths

DSP Combined 1 Free Revision Test SAIL JO E-0

GPOE / GPA Combined 1 Free Revision Test SAIL JO E-0

BSP Plant Specific Review Test SAIL JO E-0

BSL Combined 1 Free Revision Test SAIL JO E-0

GFM Combined 1 Free Revision Test SAIL JO E-0