A flanged pipe joint will be a leak-proof joint, if the circumferential pitch of the bolts is (where d = Diameter of bolt hole) Options: A . &nbspLess than 20d B . &nbspGreater than 30d C . &nbspBetween 20d and 30d D . &nbspEqual to inside diameter of pipe

A flanged pipe joint will be a leak-proof joint, if the circumferential pitch of

Question

A flanged pipe joint will be a leak-proof joint, if the circumferential pitch of the bolts is (where d = Diameter of bolt hole)

Options:

A . Less than 20d

B . Greater than 30d

C . Between 20d and 30d

D . Equal to inside diameter of pipe

Answer: Option C

Submit Your Solution Below and Earn Points !

Next Question

Question 1. The diameter of the rivet hole is usually __________ the nominal diameter of the rivet.....

Question 2. In designing a flange coupling, the pitch circle diameter of bolts is taken as (where d = Diameter of the shaft)....

Question 3. In designing a sleeve coupling, length of the sleeve is taken as (where d = Diameter of the shaft)....

Question 4. In designing a sleeve coupling, outer diameter of the sleeve is taken as (where d = Diameter of the shaft)....

Question 5. For a square key made of mild steel, the shear and crushing strength are related as....

Question 6. The dynamic tooth load is due to....

Question 7. When the material of key and shaft is same, and the width of key is one-fourth of the diameter of shaft (d), then length....diameter of shaft (d), then length of key will be

Question 8. The permissible stress in the fillet weld is 100 N/mm². The fillet weld has equal leg lengths of 15 mm each. The allowa....on the weldment per cm length of the weld is

Question 9. In a partial journal bearing, the angle of contact of the bearing with the journal is....

Question 10. In a full journal bearing, the angle of contact of the bearing with the journal is....

Chapter 1 - GLOBAL STEEL SCENARIO & INDIAN STEEL INDUSTRY Part 1 : (13-04-2024) INDUSTRY AND COMPANY AWARENESS (ICA)

Direction Sense Test Part 1 Reasoning (Hindi)

Chapter 1 - RMHP / OHP / OB & BP Part 1 : (14-02-2024) GPOE

Cube & Cuboid Part 1 Reasoning (Hindi)

Data Interpretation (DI) Basic Concept Reasoning (Hindi)

Counting Figures Part 1 Counting Of Straight Lines Reasoning (Hindi)

Sail E0 free webinar Webinars

Real Numbers Part 7 Class 10 Maths

Real Numbers Part 1 Class 10 Maths

Polynomials Part 1 Class 10 Maths

Pie Chart - Test Paper 1 Data Interpretation Reasoning & DI

Tabulation - Test Paper 2 Data Interpretation Reasoning & DI

Test Paper 1 Direction Sense Test Reasoning & DI

ICA , RDIC,GFM Free Modal Test Paper - Non - Technical Branch Old Syllabus 2022 - SAIL Junior Officer E0

GFM Combined 1 Free Revision Test SAIL JO E-0