For a square key made of mild steel, the shear and crushing strength are related as Options: A . &nbspShear strength is equal to crushing strength B . &nbspShear strength is greater than crushing strength C . &nbspShear strength is less than crushing strength D . &nbspNone of the above

For a square key made of mild steel, the shear and crushing strength are related

Question

For a square key made of mild steel, the shear and crushing strength are related as

Options:

A . Shear strength is equal to crushing strength

B . Shear strength is greater than crushing strength

C . Shear strength is less than crushing strength

D . None of the above

Answer: Option A

Submit Your Solution Below and Earn Points !

Next Question

Question 1. The dynamic tooth load is due to....

Question 2. When the material of key and shaft is same, and the width of key is one-fourth of the diameter of shaft (d), then length....diameter of shaft (d), then length of key will be

Question 3. The permissible stress in the fillet weld is 100 N/mm². The fillet weld has equal leg lengths of 15 mm each. The allowa....on the weldment per cm length of the weld is

Question 4. In a partial journal bearing, the angle of contact of the bearing with the journal is....

Question 5. In a full journal bearing, the angle of contact of the bearing with the journal is....

Question 6. If a bearing is designated by the number 305, it means that the bearing is of....

Question 7. In a flat belt drive, if the slip between the driver and belt is 1 %, between the belt and follower is 3% and driver and....are equal, then velocity ratio of the drive will be

Question 8. The static tooth load should be __________ the dynamic load.....

Question 9. The wear load should be __________ the dynamic load.....

Question 10. In designing a key, it is assumed that the distribution of forces along the length of key....

Chapter 1 - GLOBAL STEEL SCENARIO & INDIAN STEEL INDUSTRY Part 1 : (13-04-2024) INDUSTRY AND COMPANY AWARENESS (ICA)

Direction Sense Test Part 1 Reasoning (Hindi)

Chapter 1 - RMHP / OHP / OB & BP Part 1 : (14-02-2024) GPOE

Cube & Cuboid Part 1 Reasoning (Hindi)

Data Interpretation (DI) Basic Concept Reasoning (Hindi)

Counting Figures Part 1 Counting Of Straight Lines Reasoning (Hindi)

Sail E0 free webinar Webinars

Real Numbers Part 7 Class 10 Maths

Real Numbers Part 1 Class 10 Maths

Polynomials Part 1 Class 10 Maths

Pie Chart - Test Paper 1 Data Interpretation Reasoning & DI

Tabulation - Test Paper 2 Data Interpretation Reasoning & DI

Test Paper 1 Direction Sense Test Reasoning & DI

ICA , RDIC,GFM Free Modal Test Paper - Non - Technical Branch Old Syllabus 2022 - SAIL Junior Officer E0

GFM Combined 1 Free Revision Test SAIL JO E-0