In designing a sleeve coupling, length of the sleeve is taken as (where d = Diam

Question

In designing a sleeve coupling, length of the sleeve is taken as (where d = Diameter of the shaft)

Options:

A . d + 17 mm

B . 2d + 13 mm

C . 2d + 20 mm

D . 3.5 d

Answer: Option D

Submit Your Solution Below and Earn Points !

Next Question

More Questions on This Topic :

Question 1. In designing a sleeve coupling, outer diameter of the sleeve is taken as (where d = Diameter of the shaft)....

Question 2. For a square key made of mild steel, the shear and crushing strength are related as....

Question 3. The dynamic tooth load is due to....

Question 4. When the material of key and shaft is same, and the width of key is one-fourth of the diameter of shaft (d), then length....diameter of shaft (d), then length of key will be

Question 5. The permissible stress in the fillet weld is 100 N/mm². The fillet weld has equal leg lengths of 15 mm each. The allowa....on the weldment per cm length of the weld is

Question 6. In a partial journal bearing, the angle of contact of the bearing with the journal is....

Question 7. In a full journal bearing, the angle of contact of the bearing with the journal is....

Question 8. If a bearing is designated by the number 305, it means that the bearing is of....

Question 9. In a flat belt drive, if the slip between the driver and belt is 1 %, between the belt and follower is 3% and driver and....are equal, then velocity ratio of the drive will be

Question 10. The static tooth load should be __________ the dynamic load.....

Chapter 1 - GLOBAL STEEL SCENARIO & INDIAN STEEL INDUSTRY Part 1 : (13-04-2024) INDUSTRY AND COMPANY AWARENESS (ICA)

Direction Sense Test Part 1 Reasoning (Hindi)

Chapter 1 - RMHP / OHP / OB & BP Part 1 : (14-02-2024) GPOE

Cube & Cuboid Part 1 Reasoning (Hindi)

Data Interpretation (DI) Basic Concept Reasoning (Hindi)

Counting Figures Part 1 Counting Of Straight Lines Reasoning (Hindi)

Sail E0 free webinar Webinars

Real Numbers Part 7 Class 10 Maths

Real Numbers Part 1 Class 10 Maths

Polynomials Part 1 Class 10 Maths

Pie Chart - Test Paper 1 Data Interpretation Reasoning & DI

Tabulation - Test Paper 2 Data Interpretation Reasoning & DI

Test Paper 1 Direction Sense Test Reasoning & DI

ICA , RDIC,GFM Free Modal Test Paper - Non - Technical Branch Old Syllabus 2022 - SAIL Junior Officer E0

GFM Combined 1 Free Revision Test SAIL JO E-0