The distance between the top of the slots and the liquid surface when the static

Sail E0 Webinar

Question

The distance between the top of the slots and the liquid surface when the static liquid is just ready to flow over the overflow weir is called

Options:

A . Downcomer liquid seal

B . Skirt clearance

C . Static submergence

D . None of these

Answer: Option C

Submit Your Solution Below and Earn Points !

Next Question

Submit Solution

More Questions on This Topic :

Question 1. Liquid gradient over the tray results due to the....

Question 2. Which of the following packing materials provides for maximum mass transfer?....

Question 3. Heat transfer co-efficient, hG(Kcal/hr.m² .°C) and mass velocity of air, G (kg/hr.m² ) for air flow parallel to the s....perpendicular to the surface is encountered, this equation changes to

Question 4. In inclined long tube vertical evaporators, the tubes are inclined at an angle of....

Question 5. With increase in the number of shell passes, the value of FT....

Question 6. In a multipass shell and tube heat exchanger, the problem of differential expansion between the shell and tube passes is....and tube passes is taken care of by using a

Question 7. Normally, the ratio of the total riser area to the tower cross sectional area (for bubble cap towers of diameter more th....cap towers of diameter more than 3 ft) is around

Question 8. The design stress, which is more than the damaging stress, is the least unit stress that will render a member unfit for ....indicates the margin between design stress and the __________ stress.

Question 9. Pick out the wrong statement about the design of a sieve plate column.....

Question 10. Ponchon Savarit method is based on the use of enthalpy concentration diagram, which contains the bubble point curve (sat....equilibrium tie lines. As compared to McCabe-Thiele's method, this method

Chapter 1 - GLOBAL STEEL SCENARIO & INDIAN STEEL INDUSTRY Part 1 : (13-04-2024) INDUSTRY AND COMPANY AWARENESS (ICA)

Direction Sense Test Part 1 Reasoning (Hindi)

Chapter 1 - RMHP / OHP / OB & BP Part 1 : (14-02-2024) GPOE

Cube & Cuboid Part 1 Reasoning (Hindi)

Data Interpretation (DI) Basic Concept Reasoning (Hindi)

Counting Figures Part 1 Counting Of Straight Lines Reasoning (Hindi)

Sail E0 free webinar Webinars

Real Numbers Part 7 Class 10 Maths

Real Numbers Part 1 Class 10 Maths

Polynomials Part 1 Class 10 Maths

Chapter 3.1 : INTRODUCTION Chapter 3 : Sinter Plant SAIL E0 - GPOE/GPA 2024

Chapter 2.3 : COAL HANDLING PLANT - Set 1 Chapter 2 : Coke Ovens and Coal Chemicals SAIL E0 - GPOE/GPA 2024

Chapter 1.1 : INTRODUCTION Chapter 1 : Raw Material Handling Plant SAIL E0 - GPOE/GPA 2024

GPOE / GPA Combined 1 Free Revision Test SAIL JO E-0

DSP Combined 1 Free Revision Test SAIL JO E-0