The correction applied to the measured base of length ‘L’ is

Sail E0 Webinar

Question

The correction applied to the measured base of length ‘L’ is

Options:

A . Tension = (P - Ps)L/AE

B . Sag = L³w²/24P² where w is the weight of tape/m

C . Slope = (h²/2L) + (h⁴/8L³) where h is height difference of end supports

D . All the above

Answer: Option D

Submit Your Solution Below and Earn Points !

Next Question

Submit Solution

More Questions on This Topic :

Question 1. The shortest distance between two places measured along the surface of the earth, is....

Question 2. Longitude of a place is the angular distance between the meridian of the place and....

Question 3. If the altitudes of a star at its upper and lower transits are 60° 30' and 19° 30' respectively, the latitude of the p....and 19° 30' respectively, the latitude of the place, is

Question 4. The altitudes of a circumpolar star at culminations are 70° and 10°, both culminations being north of zenith. The lati....being north of zenith. The latitude of the place, is

Question 5. For plane ground the scale of a vertical photograph will be same as that of a tiled photograph along the photo parallel ....that of a tiled photograph along the photo parallel through

Question 6. Triangulation surveys are carried out for locating....

Question 7. If the general ground level of any area is 10% of the flying height, the principal points may be used as the centers of ....for small scale mapping even in tilted photograph up to

Question 8. A star is said to elongate....

Question 9. If the intercept on a vertical staff is ob-served as 0.75 m from a tacheometer, the horizontal distance between tacheome....tacheometer, the horizontal distance between tacheometer and staff station is

Question 10. The latitude of a place was obtained by subtracting the zenith distance of a star from its declination, the observed sta....a star from its declination, the observed star was between

Chapter 1 - GLOBAL STEEL SCENARIO & INDIAN STEEL INDUSTRY Part 1 : (13-04-2024) INDUSTRY AND COMPANY AWARENESS (ICA)

Direction Sense Test Part 1 Reasoning (Hindi)

Chapter 1 - RMHP / OHP / OB & BP Part 1 : (14-02-2024) GPOE

Cube & Cuboid Part 1 Reasoning (Hindi)

Data Interpretation (DI) Basic Concept Reasoning (Hindi)

Counting Figures Part 1 Counting Of Straight Lines Reasoning (Hindi)

Sail E0 free webinar Webinars

Real Numbers Part 7 Class 10 Maths

Real Numbers Part 1 Class 10 Maths

Polynomials Part 1 Class 10 Maths

Chapter 3.1 : INTRODUCTION Chapter 3 : Sinter Plant SAIL E0 - GPOE/GPA 2024

Chapter 2.3 : COAL HANDLING PLANT - Set 1 Chapter 2 : Coke Ovens and Coal Chemicals SAIL E0 - GPOE/GPA 2024

Chapter 1.1 : INTRODUCTION Chapter 1 : Raw Material Handling Plant SAIL E0 - GPOE/GPA 2024

GPOE / GPA Combined 1 Free Revision Test SAIL JO E-0

DSP Combined 1 Free Revision Test SAIL JO E-0