The basic stress in masonry units having height to width ratio of 1.5 may be inc

Question

The basic stress in masonry units having height to width ratio of 1.5 may be increased by a factor of

Options:

A . 1.2

B . 1.4

C . 1.6

D . 2.0

Answer: Option C

Submit Your Solution Below and Earn Points !

Next Question

More Questions on This Topic :

Question 1. Minimum compressive strength in N/mm² for H1 type mortar used for masonry is....

Question 2. For designing masonry components of a structure, seismic forces provision in the design calculation is not necessary for....the design calculation is not necessary for buildings constructed in

Question 3. A 200 mm thick wall made of modular bricks is 5 m long between cross walls and 3.8 m clear height between RCC slabs at t....top and bottom. The slenderness ratio of the wall is

Question 4. In a cavity wall, both leaves of which are load bearing, the effective thickness is taken as....

Question 5. The mode of failure of a very short masonry member having h/t ratio of less than 4 is by....

Question 6. If the ratio of center to center spacing of intersecting walls to actual thickness of intersecting wall is more than 20,....20, then the stiffening coefficient for wall proper will be

Question 7. Where a structural component or a system is providing lateral support to five or more walls or columns, the lateral load....the most heavily loaded wall or column in the group

Question 8. If the horizontal cross-sectional area of a wall is 1200 cm², then the basic stress shall be multiplied by a reduction ....stress shall be multiplied by a reduction factor equal to

Question 9. If ‘H’ is the height of wall between centers of supports, then the effective height of wall where concrete floors ha....on wall irrespective of the direction of span will be

Question 10. Cement mortars richer than 1 : 3 are not used in masonry because(i) There is no gain in strength of masonry(ii) There is....masonry(ii) There is high shrinkage(iii) They are prone to segregation

Chapter 1 - GLOBAL STEEL SCENARIO & INDIAN STEEL INDUSTRY Part 1 : (13-04-2024) INDUSTRY AND COMPANY AWARENESS (ICA)

Direction Sense Test Part 1 Reasoning (Hindi)

Chapter 1 - RMHP / OHP / OB & BP Part 1 : (14-02-2024) GPOE

Cube & Cuboid Part 1 Reasoning (Hindi)

Data Interpretation (DI) Basic Concept Reasoning (Hindi)

Counting Figures Part 1 Counting Of Straight Lines Reasoning (Hindi)

Sail E0 free webinar Webinars

Real Numbers Part 7 Class 10 Maths

Real Numbers Part 1 Class 10 Maths

Polynomials Part 1 Class 10 Maths

Pie Chart - Test Paper 1 Data Interpretation Reasoning & DI

Tabulation - Test Paper 2 Data Interpretation Reasoning & DI

Test Paper 1 Direction Sense Test Reasoning & DI

ICA , RDIC,GFM Free Modal Test Paper - Non - Technical Branch Old Syllabus 2022 - SAIL Junior Officer E0

GFM Combined 1 Free Revision Test SAIL JO E-0