If the ratio of center to center spacing of intersecting walls to actual thickne

Question

If the ratio of center to center spacing of intersecting walls to actual thickness of intersecting wall is more than 20, then the stiffening coefficient for wall proper will be

Options:

A . 0

B . Between 0 and 1

C . 1

D . Greater than 1

Answer: Option D

Submit Your Solution Below and Earn Points !

Next Question

Submit Solution

More Questions on This Topic :

Question 1. Where a structural component or a system is providing lateral support to five or more walls or columns, the lateral load....the most heavily loaded wall or column in the group

Question 2. If the horizontal cross-sectional area of a wall is 1200 cm², then the basic stress shall be multiplied by a reduction ....stress shall be multiplied by a reduction factor equal to

Question 3. If ‘H’ is the height of wall between centers of supports, then the effective height of wall where concrete floors ha....on wall irrespective of the direction of span will be

Question 4. Cement mortars richer than 1 : 3 are not used in masonry because(i) There is no gain in strength of masonry(ii) There is....masonry(ii) There is high shrinkage(iii) They are prone to segregation

Question 5. If the eccentricity ratio is more than 1/24, then increase in the permissible stress in the design of wall subjected to ....of wall subjected to eccentric loading as per code is

Question 6. A 200 mm thick brick masonry wall made of modular bricks carries an axial load of 30 kN/m from wall above and an eccentr....centre line of the wall. The resultant eccentricity ratio is

Question 7. Consider the following statements:1. Masonry in rich cement mortar though having good strength with high shrinkage is mu....to masonry in cement mortar.Which of these statements are correct?

Question 8. The bending stress in a wall or column subjected to effective vertical load need not be considered, if the eccentricity ....load need not be considered, if the eccentricity ratio is

Question 9. Assertion A : Lime based mortars give higher ratio of brickwork strength to mortar strength as compared to non-lime mort....non-lime mortars.Select your answer according to the codes given below:

Question 10. Assertion A : From consideration of structural soundness and economy of design, most codes control the maximum slenderne....by buckling. Select your answer according to codes given below:

Chapter 1 - GLOBAL STEEL SCENARIO & INDIAN STEEL INDUSTRY Part 1 : (13-04-2024) INDUSTRY AND COMPANY AWARENESS (ICA)

Direction Sense Test Part 1 Reasoning (Hindi)

Chapter 1 - RMHP / OHP / OB & BP Part 1 : (14-02-2024) GPOE

Cube & Cuboid Part 1 Reasoning (Hindi)

Data Interpretation (DI) Basic Concept Reasoning (Hindi)

Counting Figures Part 1 Counting Of Straight Lines Reasoning (Hindi)

Sail E0 free webinar Webinars

Real Numbers Part 7 Class 10 Maths

Real Numbers Part 1 Class 10 Maths

Polynomials Part 1 Class 10 Maths

Pie Chart - Test Paper 1 Data Interpretation Reasoning & DI

Tabulation - Test Paper 2 Data Interpretation Reasoning & DI

Test Paper 1 Direction Sense Test Reasoning & DI

ICA , RDIC,GFM Free Modal Test Paper - Non - Technical Branch Old Syllabus 2022 - SAIL Junior Officer E0

GFM Combined 1 Free Revision Test SAIL JO E-0

Submit Solution

More Questions on This Topic :

Latest Videos

Latest Test Papers