In the case of panel wall subjected to horizontal loads at right angles to the p

Question

In the case of panel wall subjected to horizontal loads at right angles to the plane of the wall, with the mortar not leaner than Ml type, tensile stress in bending in the vertical direction may be allowed to the extent of

Options:

A . 0.4 kg/cm²

B . 0.7 kg/cm²

C . 1.0 kg/cm²

D . 1.2 kg/cm²

Answer: Option C

Submit Your Solution Below and Earn Points !

Next Question

Submit Solution

More Questions on This Topic :

Question 1. For earthquake resistant masonry buildings, where seismic coefficient is less than 0.08, the horizontal distance between....horizontal distance between two openings shall not be less than

Question 2. Consider the following statements:A high lime content in a composite cement-lime mortar results in1. Slow hardening.2. Q....cement-lime mortar results in1. Slow hardening.2. Quick setting.3. Weaker mortar.

Question 3. Full restraint is provided by(i) Foundation footing of a wall(ii) Timber floor spanning on the wall and anchored to the ....with a minimum bearing of 10 cm on the wall

Question 4. For strengthening a 50 m long and 5 m high straight compound wall built in brick work, which one of the following would ....work, which one of the following would be most suitable?

Question 5. Assertion A : For eccentricity ratio exceeding 1/6, effective thickness of masonry will get reduced.Reason R : For eccen....member. Select your answer according to the codes give below:

Question 6. Consider the following statements regarding bands to be provided for strengthening masonry work in masonry buildings con....of reinforced concrete only.of these statements, the correct statements are

Question 7. Consider the following statements regarding provision of chases in masonry,(i) No chase should be permitted in a half br....should be provided near to bearings of beams and lintels.

Question 8. The basic stress in masonry units having height to width ratio of 1.5 may be increased by a factor of....

Question 9. Minimum compressive strength in N/mm² for H1 type mortar used for masonry is....

Question 10. For designing masonry components of a structure, seismic forces provision in the design calculation is not necessary for....the design calculation is not necessary for buildings constructed in

Chapter 1 - GLOBAL STEEL SCENARIO & INDIAN STEEL INDUSTRY Part 1 : (13-04-2024) INDUSTRY AND COMPANY AWARENESS (ICA)

Direction Sense Test Part 1 Reasoning (Hindi)

Chapter 1 - RMHP / OHP / OB & BP Part 1 : (14-02-2024) GPOE

Cube & Cuboid Part 1 Reasoning (Hindi)

Data Interpretation (DI) Basic Concept Reasoning (Hindi)

Counting Figures Part 1 Counting Of Straight Lines Reasoning (Hindi)

Sail E0 free webinar Webinars

Real Numbers Part 7 Class 10 Maths

Real Numbers Part 1 Class 10 Maths

Polynomials Part 1 Class 10 Maths

Pie Chart - Test Paper 1 Data Interpretation Reasoning & DI

Tabulation - Test Paper 2 Data Interpretation Reasoning & DI

Test Paper 1 Direction Sense Test Reasoning & DI

ICA , RDIC,GFM Free Modal Test Paper - Non - Technical Branch Old Syllabus 2022 - SAIL Junior Officer E0

GFM Combined 1 Free Revision Test SAIL JO E-0

Submit Solution

More Questions on This Topic :

Latest Videos

Latest Test Papers