In order to determine the stresses in a thin cylinder due to an internal pressure, it is assumed that Options: A . &nbspThe effect of curvature of the cylinder wall is neglected B . &nbspThe tensile stresses are uniformly distributed over the section of the walls C . &nbspThe effect of the restraining action of the heads at the end of the pressure vessel is neglected D . &nbspAll of the above

In order to determine the stresses in a thin cylinder due to an internal pressur

Question

In order to determine the stresses in a thin cylinder due to an internal pressure, it is assumed that

Options:

A . The effect of curvature of the cylinder wall is neglected

B . The tensile stresses are uniformly distributed over the section of the walls

C . The effect of the restraining action of the heads at the end of the pressure vessel is neglected

D . All of the above

Answer: Option D

Submit Your Solution Below and Earn Points !

Next Question

Question 1. A rivet is specified by....

Question 2. Resilience of a material is important, when it is subjected to....

Question 3. In testing a material for endurance strength, it is subjected to....

Question 4. A shaft is subjected to....

Question 5. When the belt speed increases....

Question 6. If a spring is cut down into two springs, the stiffness of cut springs will be....

Question 7. In helical bevel gearing, the axes of shafts are __________ and the teeth are curved.....

Question 8. In worm, gears, pitch lead angle is....

Question 9. A flanged pipe joint will be a leak-proof joint, if the circumferential pitch of the bolts is (where d = Diameter of bol....the bolts is (where d = Diameter of bolt hole)

Question 10. The diameter of the rivet hole is usually __________ the nominal diameter of the rivet.....

Chapter 1 - GLOBAL STEEL SCENARIO & INDIAN STEEL INDUSTRY Part 1 : (13-04-2024) INDUSTRY AND COMPANY AWARENESS (ICA)

Direction Sense Test Part 1 Reasoning (Hindi)

Chapter 1 - RMHP / OHP / OB & BP Part 1 : (14-02-2024) GPOE

Cube & Cuboid Part 1 Reasoning (Hindi)

Data Interpretation (DI) Basic Concept Reasoning (Hindi)

Counting Figures Part 1 Counting Of Straight Lines Reasoning (Hindi)

Sail E0 free webinar Webinars

Real Numbers Part 7 Class 10 Maths

Real Numbers Part 1 Class 10 Maths

Polynomials Part 1 Class 10 Maths

GPOE / GPA Combined 1 Free Mock Test SAIL JO E-0 2024

Chapter 3.1 : INTRODUCTION Chapter 3 : Sinter Plant SAIL E0 - GPOE/GPA 2024

Chapter 2.3 : COAL HANDLING PLANT - Set 1 Chapter 2 : Coke Ovens and Coal Chemicals SAIL E0 - GPOE/GPA 2024

Chapter 1.1 : INTRODUCTION Chapter 1 : Raw Material Handling Plant SAIL E0 - GPOE/GPA 2024

DSP Combined 1 Free Revision Test SAIL JO E-0