Draw a circle with center O with radius 5 cm. Draw any one of the diameters. Wi

Sail E0 Webinar

Question

Draw a circle with center O with radius 5 cm. Draw any one of the diameters. With same center A, draw another circle with radius 3 cm. Draw any one of the diameters for this circle too. If you join the ends of both the diameters, the figure you will get is:

Options:

A . Parallelogram

B . Rectangle

C . Square

D . Trapezium

Answer: Option A
:
A

Draw the circles and the diameters. You will get:

If you mark the diameter of smaller circle as AB and larger circle as CD, after joining them you will get:

Fig. ABCD is a parallelogram. When AB is perpendicular to CD, ABCD becomes a rhombus.

Was this answer helpful ?

Next Question

Submit Solution

More Questions on This Topic :

Question 1. If AB is perpendicular to CD and PQ is perpendicular to AB, which of the following is/are true?....

Question 2. Which is the easiest and most accurate method to copy a given line segment AB? ....

Question 3. Draw a line AB. At A, draw an arc of length 3cm using compass such that it intersects AB at O. With the same spread of c....the protractor, measure ∠QAB. What is the value of ∠QAB.

Question 4. Which of the following is an example of perpendicular lines? 1. Corners of your circular room floor. 2. One of the a....minute hand when it is 12:15 in your wall clock.

Question 5. Using which of the following, it is not possible to construct a 60∘ angle? ....

Question 6. If number of ends in a line is 'X' and the number of ends in a line segment is 'Y', what is the value of 'Y−X'? __ ....line segment is 'Y', what is the value of 'Y−X'? __

Question 7. If you have two 30∘- 60∘ - 90∘ set squares, which of the following shapes is impossible to get using them?....

Question 8. Draw a circle. Now draw any of its two diameters and mark them AC and BD. Join the points A, B, C and D. If ABCD is a sq....a square, the diameters must be ___ to each other.

Question 9. It is possible to construct an angle equal to 7.5∘ using compass and ruler. ....

Question 10. Name four tools used for drawing shapes. [1 MARK] ....

Chapter 1 - GLOBAL STEEL SCENARIO & INDIAN STEEL INDUSTRY Part 1 : (13-04-2024) INDUSTRY AND COMPANY AWARENESS (ICA)

Direction Sense Test Part 1 Reasoning (Hindi)

Chapter 1 - RMHP / OHP / OB & BP Part 1 : (14-02-2024) GPOE

Cube & Cuboid Part 1 Reasoning (Hindi)

Data Interpretation (DI) Basic Concept Reasoning (Hindi)

Counting Figures Part 1 Counting Of Straight Lines Reasoning (Hindi)

Sail E0 free webinar Webinars

Real Numbers Part 7 Class 10 Maths

Real Numbers Part 1 Class 10 Maths

Polynomials Part 1 Class 10 Maths

GPOE / GPA Combined 1 Free Mock Test SAIL JO E-0 2024

ICA Combined 1 Free Revision Test SAIL JO E-0

RDIC Review Test SAIL JO E-0

Pie Chart - Test Paper 1 Data Interpretation Reasoning & DI

RSP Combined 1 Free Revision Test SAIL JO E-0