A hollow saddle key is Options: A . &nbspA taper key which fits half in the key way of hub and half in the key way of shaft B . &nbspA taper key which fits in a key way of the hub and is flat on the shaft C . &nbspA taper key which fits in a key way of the hub and the bottom of the key is shaped to fit the curved surface of the shaft D . &nbspProvided in pairs at right angles and each key is to withstand torsion in one direction only

A hollow saddle key is

Question

A hollow saddle key is

Options:

A . A taper key which fits half in the key way of hub and half in the key way of shaft

B . A taper key which fits in a key way of the hub and is flat on the shaft

C . A taper key which fits in a key way of the hub and the bottom of the key is shaped to fit the curved surface of the shaft

D . Provided in pairs at right angles and each key is to withstand torsion in one direction only

Answer: Option C

Submit Your Solution Below and Earn Points !

Next Question

Question 1. The stress in the bar when the load is applied suddenly is __________ as compared to the stress induced due to gradually....compared to the stress induced due to gradually applied loads.

Question 2. The shear stress in a beam varies from zero at the outer fibers to a maximum at the________.....

Question 3. The helix angle for double helical gears may be made up to....

Question 4. Three different weights fall from a certain height under vacuum. They will take....

Question 5. Which of the following is a permanent fastening?....

Question 6. A localized compressive stress at the area of contact between two members is known as....

Question 7. The difference between the upper limit and lower limit of a dimension is called....

Question 8. The temperature at which the new grains are formed in the metal is known as....

Question 9. When two non-parallel or intersecting but coplanar shafts are connected by gears, the arrangement is known as,....

Question 10. For general industrial machinery, the ratio of the length of journal to its diameter is taken as....

Chapter 1 - GLOBAL STEEL SCENARIO & INDIAN STEEL INDUSTRY Part 1 : (13-04-2024) INDUSTRY AND COMPANY AWARENESS (ICA)

Direction Sense Test Part 1 Reasoning (Hindi)

Chapter 1 - RMHP / OHP / OB & BP Part 1 : (14-02-2024) GPOE

Cube & Cuboid Part 1 Reasoning (Hindi)

Data Interpretation (DI) Basic Concept Reasoning (Hindi)

Counting Figures Part 1 Counting Of Straight Lines Reasoning (Hindi)

Sail E0 free webinar Webinars

Real Numbers Part 7 Class 10 Maths

Real Numbers Part 1 Class 10 Maths

Polynomials Part 1 Class 10 Maths

Pie Chart - Test Paper 1 Data Interpretation Reasoning & DI

Tabulation - Test Paper 2 Data Interpretation Reasoning & DI

Test Paper 1 Direction Sense Test Reasoning & DI

ICA , RDIC,GFM Free Modal Test Paper - Non - Technical Branch Old Syllabus 2022 - SAIL Junior Officer E0

GFM Combined 1 Free Revision Test SAIL JO E-0