Three different weights fall from a certain height under vacuum. They will take Options: A . &nbspSame time to reach earth B . &nbspTimes proportional to weight to reach earth C . &nbspTimes inversely proportional to weight to reach earth D . &nbspNone of the above

Three different weights fall from a certain height under vacuum. They will take

Question

Three different weights fall from a certain height under vacuum. They will take

Options:

A . Same time to reach earth

B . Times proportional to weight to reach earth

C . Times inversely proportional to weight to reach earth

D . None of the above

Answer: Option A

Submit Your Solution Below and Earn Points !

Next Question

Question 1. Which of the following is a permanent fastening?....

Question 2. A localized compressive stress at the area of contact between two members is known as....

Question 3. The difference between the upper limit and lower limit of a dimension is called....

Question 4. The temperature at which the new grains are formed in the metal is known as....

Question 5. When two non-parallel or intersecting but coplanar shafts are connected by gears, the arrangement is known as,....

Question 6. For general industrial machinery, the ratio of the length of journal to its diameter is taken as....

Question 7. The usual clearance provided in hydrodynamic bearing per mm of diameter of shaft is....

Question 8. The diameter of knuckle pin in a knuckle joint is usually taken as (where d = Diameter of the rod)....

Question 9. The ratio of endurance limit in shear to the endurance limit in flexure is....

Question 10. The bending moment ‘M’ and a torque ‘T’ is applied on a solid circular shaft. If the maximum bending stress equa....to maximum shear stress developed, then ‘M’ is equal to

Chapter 1 - GLOBAL STEEL SCENARIO & INDIAN STEEL INDUSTRY Part 1 : (13-04-2024) INDUSTRY AND COMPANY AWARENESS (ICA)

Direction Sense Test Part 1 Reasoning (Hindi)

Chapter 1 - RMHP / OHP / OB & BP Part 1 : (14-02-2024) GPOE

Cube & Cuboid Part 1 Reasoning (Hindi)

Data Interpretation (DI) Basic Concept Reasoning (Hindi)

Counting Figures Part 1 Counting Of Straight Lines Reasoning (Hindi)

Sail E0 free webinar Webinars

Real Numbers Part 7 Class 10 Maths

Real Numbers Part 1 Class 10 Maths

Polynomials Part 1 Class 10 Maths

Pie Chart - Test Paper 1 Data Interpretation Reasoning & DI

Tabulation - Test Paper 2 Data Interpretation Reasoning & DI

Test Paper 1 Direction Sense Test Reasoning & DI

ICA , RDIC,GFM Free Modal Test Paper - Non - Technical Branch Old Syllabus 2022 - SAIL Junior Officer E0

GFM Combined 1 Free Revision Test SAIL JO E-0