Sail E0 Webinar

MCQs

Total Questions : 530 | Page 1 of 53 pages
Question 1.  A transistor with hie = 1.5 K and hie = 75 is used in an emitter follower circuit where R1 and R2 are used for normal biasing. Approximate value of its current amplification is
  1.    75
  2.    76
  3.    75/76
  4.    ?75
 Discuss Question
Answer: Option B. -> 76
Question 2.  A certain percentage of negative feedback does not yield a fixed reduction in gain because it depends on
  1.    transistor configuration
  2.    ambient temperature
  3.    initial value of gain
  4.    leakage current of the transistor
 Discuss Question
Answer: Option C. -> initial value of gain
Question 3.  If the feedback factor of an amplifier is 0.1 and gain without feedback is 40, then its gain with feedback is
  1.    8
  2.    ?l3.3
  3.    10
  4.    200
 Discuss Question
Answer: Option A. -> 8
Question 4.   In an audio amplifier, audio signals become garbled and hence difficult to understand when ac input current is large enough to drive the output to
  1.    saturation only
  2.    cut-off only
  3.    either saturation or cut-off
  4.    a value off the load line
 Discuss Question
Answer: Option C. -> either saturation or cut-off
Question 5.  An amplifier has a bandwidth of 20 kHz and a midband gain of 50 without feedback. If a negative feedback of 1% is applied, than bandwidth with feedback is ?kHz.
  1.    13.3
  2.    30
  3.    10
  4.    40
 Discuss Question
Answer: Option B. -> 30
Question 6.  Regarding improvements obtained by using negative voltage feedback which statement is false?
  1.    increased gain stability
  2.    increased bandwidth
  3.    increased noise
  4.    decreased distortion
 Discuss Question
Answer: Option C. -> increased noise
Question 7.  An amplifier without feedback has a distortion of 15% and gain of 40. When 10% negative feedback is applied, the distortion will become ?percent.
  1.    50
  2.    ?45
  3.    3
  4.    ?5
 Discuss Question
Answer: Option C. -> 3
Question 8.  A CE amplifier is characterised by
  1.    low voltage gain
  2.    moderate power gain
  3.    signal phase reversal
  4.    very high outupt impedance
 Discuss Question
Answer: Option C. -> signal phase reversal
Question 9.   In a CC amplifier, voltage gain
  1.    cannot qceed unity
  2.    depends on output impedance
  3.    is dependent on input signal
  4.    is always constant
 Discuss Question
Answer: Option A. -> cannot qceed unity
Question 10. . A transistor amplifier with 85% efficiency is likely to be class ?
  1.    A
  2.    B
  3.    C
  4.    AB
 Discuss Question
Answer: Option C. -> C

Latest Videos
Chapter 1 - GLOBAL STEEL SCENARIO & INDIAN STEEL INDUSTRY Part 1 : (13-04-2024) INDUSTRY AND COMPANY AWARENESS (ICA)
Direction Sense Test Part 1 Reasoning (Hindi)
Chapter 1 - RMHP / OHP / OB & BP Part 1 : (14-02-2024) GPOE
Cube & Cuboid Part 1 Reasoning (Hindi)
Data Interpretation (DI) Basic Concept Reasoning (Hindi)
Counting Figures Part 1 Counting Of Straight Lines Reasoning (Hindi)
Sail E0 free webinar Webinars
Real Numbers Part 7 Class 10 Maths
Real Numbers Part 1 Class 10 Maths
Polynomials Part 1 Class 10 Maths

Latest Test Papers

Pie Chart - Test Paper 1 Data Interpretation Reasoning & DI
Tabulation - Test Paper 2 Data Interpretation Reasoning & DI
Test Paper 1 Direction Sense Test Reasoning & DI
ICA , RDIC,GFM Free Modal Test Paper - Non - Technical Branch Old Syllabus 2022 - SAIL Junior Officer E0
GFM Combined 1 Free Revision Test SAIL JO E-0