Questions and answers for exam Preparation

MCQs

Total Questions : 329 | Page 11 of 33 pages

Question 101. The coordinates of the ends of a runway are (5000, 5000) and (8000, 7000). The co-ordinates of another runway are (4600, 5100) and (7000, 5300). The co-ordinates of the A.R.P. are

(6500, 6000)
(5800, 5200)
(61500, 5600)
(8000, 7000)

Discuss Question

Answer: Option C. -> (61500, 5600)

Question 102. Pick up the correct statement from the following:

Air screw converts the energy given by the engine into speed
The propellers which are driven by turbine engines, are technically called turboprops
The aircrafts which obtain the thrust directly from turbine engine, are called turbo-jets
All the above

Discuss Question

Answer: Option D. -> All the above

Question 103. Pick up the correct statement from the following:

Approach zone survey is carried out to determine the elevations of the protruding obstructions above horizontal, conical and transitional surfaces
The wind data of an air port is depicted in the form of a chart known as wind rose
The landing and takeoff of the air craft is made against the wind direction
All the above

Discuss Question

Answer: Option D. -> All the above

Question 104. Pick up the correct statement from the following:

Approximate geometric centre of the landing area, is called air port reference point
The boundaries of horizontal surface and conical surface are marked with reference to air port reference point
The location of the air port on a map is the position of air port reference point
All the above

Discuss Question

Answer: Option D. -> All the above

Question 105. Pick up the incorrect statement from the following:

Channelization of pavement is caused by constant use of tri-cycle gears of aircraft
Blast pads are used over cohesion-less soils to resist erosion due to tremendous speed of the jet blast
Over-run areas of at least 300 m length on either side of the runway are provided
None of these

Discuss Question

Answer: Option D. -> None of these

Question 106. Pick up the correct statement from the following:

F.I.R. stands for flight information regions
Radius of control area is 160 km
Radius of control zone is 40 km
All the above

Discuss Question

Answer: Option D. -> All the above

Question 107. Pick up the incorrect statement from the following:

In single engine aeroplanes, the engine is provided in the nose of the aircraft
In double engine aeroplanes, one engine on either wing is placed symmetrically
In three engine aeroplanes, two engines are placed on both wings and one engine is placed in the tail
None of these

Discuss Question

Answer: Option C. -> In three engine aeroplanes, two engines are placed on both wings and one engine is placed in the tail

Question 108. Pick up the incorrect statement from the following:

L.O.M. is installed at 7.2 km from the threshold
L.M.M. is installed at 1.0 km from the threshold
Localizer antenna is installed at 300 m from the other end of the runway
Glide slope antenna is installed at the centre of the runway about 150 m on one side

Discuss Question

Answer: Option D. -> Glide slope antenna is installed at the centre of the runway about 150 m on one side

Question 109. Pick up the correct abbreviation from the following:

L.M.M. (low powered middle marker)
V.H.F. (very high frequency)
L.O.M. (low powered outer marker)
All the above

Discuss Question

Answer: Option D. -> All the above

Question 110. Pick up the correct statement from the following:

Landing speed is directly proportional to the wing loading
Wing loading remaining constant, the take off distance is directly proportional to the powder loading
Neither (A) nor (B)
Both (A) and (B)

Discuss Question

Answer: Option D. -> Both (A) and (B)