this is the most common application for developments and intersections: Options: A . &nbsp Sheet metal construction B . &nbsp Piping C . &nbsp Architecture D . &nbsp Mechanical engineering

this is the most common application for developments and intersections:

Question

This is the most common application for developments and intersections:

Options:

A . Sheet metal construction

B . Piping

C . Architecture

D . Mechanical engineering

Answer: Option A

Submit Your Solution Below and Earn Points !

Next Question

Question 1. The primary unit of measurement for engineering drawings and design in the mechanical industries is the:....

Question 2. This type of projection is when projectors are parallel to each other, but are at an angle other than 90 degrees to the ....angle other than 90 degrees to the plane of projection:

Question 3. Referring to the fractional inches to decimal inches to millimeter conversion chart on page 55 what is the equivalent mm....55 what is the equivalent mm measurement of 3/16 inch.

Question 4. In offset sections, offsets or bends in the cutting plane are all:....

Question 5. In working drawings, these show all necessary information not given directly on the drawing with its dimensions and note....given directly on the drawing with its dimensions and notes:

Question 6. On a floor plan the dashed line that appears approximately 24" outside the exterior wall represents the ________.....

Question 7. The auto-cad command used to combine two or more primitive shapes into a single complex 3-dimensional model is ________.....primitive shapes into a single complex 3-dimensional model is ________.

Question 8. The daily workload of a ________ drafter would generally include technical drawings of machine parts.....

Question 9. Given a situation in which the drafter has crossed extension lines in a drawing what can be done to clean up the point o....can be done to clean up the point of crossing?

Question 10. On typical electronic diagrams, these items need not be shown unless they are needed for clarification:....

Chapter 1 - GLOBAL STEEL SCENARIO & INDIAN STEEL INDUSTRY Part 1 : (13-04-2024) INDUSTRY AND COMPANY AWARENESS (ICA)

Direction Sense Test Part 1 Reasoning (Hindi)

Chapter 1 - RMHP / OHP / OB & BP Part 1 : (14-02-2024) GPOE

Cube & Cuboid Part 1 Reasoning (Hindi)

Data Interpretation (DI) Basic Concept Reasoning (Hindi)

Counting Figures Part 1 Counting Of Straight Lines Reasoning (Hindi)

Sail E0 free webinar Webinars

Real Numbers Part 7 Class 10 Maths

Real Numbers Part 1 Class 10 Maths

Polynomials Part 1 Class 10 Maths

Pie Chart - Test Paper 1 Data Interpretation Reasoning & DI

Tabulation - Test Paper 2 Data Interpretation Reasoning & DI

Test Paper 1 Direction Sense Test Reasoning & DI

ICA , RDIC,GFM Free Modal Test Paper - Non - Technical Branch Old Syllabus 2022 - SAIL Junior Officer E0

GFM Combined 1 Free Revision Test SAIL JO E-0