The flux density at a point in space is given by B = 4 xax + 2kyay + 8 az Wb/m2

Sail E0 Webinar

Question

The flux density at a point in space is given by B = 4 xax + 2kyay + 8 az Wb/m2. The value of constant k must be equal to

Options:

A . -2

B . -0.5

C . +0.5

D . +2

Answer: Option A

-NA-

Was this answer helpful ?

Next Question

Submit Solution

More Questions on This Topic :

Question 1. A single-phase transformer has no-load loss of 64 W, as obtained from an open-circuit test. When a short-circuit test ....81 W. The transformer has maximum efficiency when operated at

Question 2. A source vs (t) = V cos 100 Ï€t has an internal impedance of (4 + j3)â„¦ . If a purely resistive load connected....of the source, its value in â„¦ should be

Question 3. A single-phase load is supplied by a single-phase voltage source. If the current flowing from the load to the source is....voltage at the load terminals is 100âˆ 60o V, then the

Question 4. A bulb in a staircase has two switches, one switch being at the ground floor and the other one at the first floor. The....other switch. The logic of switching of the bulb resembles

Question 5. The angle Î´ in the swing equation of a synchronous generator is the ....

Question 6. For a periodic signal v(t) = 30 sin100t + 10 cos 300t + 6 sin (500t + Ï€ / 4) , the fundamental frequency in rad/s i....Ï€ / 4) , the fundamental frequency in rad/s is

Question 7. A band-limited signal with a maximum frequency of 5 kHz is to be sampled. According to the sampling theorem, the sampl....the sampling frequency in kHz which is not valid is

Question 8. For a power system network with n nodes, Z33 of its bus impedance matrix is j0.5 per unit. The voltage at node 3 is 1.3....node, the current drawn by the capacitor per unit is

Question 9. A dielectric slab with 500 mm Ã— 500 mm cross-section is 0.4 m long. The slab is subjected to a uniform electric fie....F/m. The energy stored in the dielectric in Joules is

Question 10. The impulse response of a continuous time system is given by h(t) = Î´(t -1) + Î´(t - 3) . The value of the step re....value of the step response at t = 2 is

Chapter 1 - GLOBAL STEEL SCENARIO & INDIAN STEEL INDUSTRY Part 1 : (13-04-2024) INDUSTRY AND COMPANY AWARENESS (ICA)

Direction Sense Test Part 1 Reasoning (Hindi)

Chapter 1 - RMHP / OHP / OB & BP Part 1 : (14-02-2024) GPOE

Cube & Cuboid Part 1 Reasoning (Hindi)

Data Interpretation (DI) Basic Concept Reasoning (Hindi)

Counting Figures Part 1 Counting Of Straight Lines Reasoning (Hindi)

Sail E0 free webinar Webinars

Real Numbers Part 7 Class 10 Maths

Real Numbers Part 1 Class 10 Maths

Polynomials Part 1 Class 10 Maths

GPOE / GPA Combined 1 Free Mock Test SAIL JO E-0 2024

Chapter 3.1 : INTRODUCTION Chapter 3 : Sinter Plant SAIL E0 - GPOE/GPA 2024

Chapter 2.3 : COAL HANDLING PLANT - Set 1 Chapter 2 : Coke Ovens and Coal Chemicals SAIL E0 - GPOE/GPA 2024

Chapter 1.1 : INTRODUCTION Chapter 1 : Raw Material Handling Plant SAIL E0 - GPOE/GPA 2024

DSP Combined 1 Free Revision Test SAIL JO E-0