The edges of the boiler plates are bevelled to an angle of

Sail E0 Webinar

Question

The edges of the boiler plates are bevelled to an angle of

Options:

A . 45°

B . 60°

C . 70°

D . 80°

Answer: Option D
Answer: (d).80°

Was this answer helpful ?

Next Question

Submit Solution

More Questions on This Topic :

Question 1. The smallest diameter of an external or internal screw thread is known as....

Question 2. Which of the following statement is wrong ?....

Question 3. The process which improves the machinability of steels, but lowers the hardness and tensile strength is....

Question 4. The coefficient of friction between the belt and pulley depends upon the....

Question 5. The relation between the pitch of the chain (p) and pitch circle diameter of the sprocket (D) is given by (where T = Num....by (where T = Number of teeth on the sprocket)

Question 6. The interference may only be avoided if the addendum circles of the two mating gears cut the common tangent to the base ....tangent to the base circles between the points of tangency.

Question 7. The permissible stress in the fillet weld is 100 N/mm². The fillet weld has equal leg lengths of 15 mm each. The al....on the weldment per cm length of the weld is

Question 8. The stress which vary from a minimum value to a maximum value of the same nature (i.e. tensile or compressive) is called....of the same nature (i.e. tensile or compressive) is called

Question 9. The spigot and socket joint is mostly used for pipes which are burried in the earth.....

Question 10. When the material of key and shaft is same, and the width of key is one-fourth of the diameter of shaft (d), then length....diameter of shaft (d), then length of key will be

Chapter 1 - GLOBAL STEEL SCENARIO & INDIAN STEEL INDUSTRY Part 1 : (13-04-2024) INDUSTRY AND COMPANY AWARENESS (ICA)

Direction Sense Test Part 1 Reasoning (Hindi)

Chapter 1 - RMHP / OHP / OB & BP Part 1 : (14-02-2024) GPOE

Cube & Cuboid Part 1 Reasoning (Hindi)

Data Interpretation (DI) Basic Concept Reasoning (Hindi)

Counting Figures Part 1 Counting Of Straight Lines Reasoning (Hindi)

Sail E0 free webinar Webinars

Real Numbers Part 7 Class 10 Maths

Real Numbers Part 1 Class 10 Maths

Polynomials Part 1 Class 10 Maths

GPOE / GPA Combined 1 Free Mock Test SAIL JO E-0 2024

Chapter 3.1 : INTRODUCTION Chapter 3 : Sinter Plant SAIL E0 - GPOE/GPA 2024

Chapter 2.3 : COAL HANDLING PLANT - Set 1 Chapter 2 : Coke Ovens and Coal Chemicals SAIL E0 - GPOE/GPA 2024

Chapter 1.1 : INTRODUCTION Chapter 1 : Raw Material Handling Plant SAIL E0 - GPOE/GPA 2024

DSP Combined 1 Free Revision Test SAIL JO E-0