The centre of gravity of a trapezoidal dam section whose top width is a, bottom

Sail E0 Webinar

Question

The centre of gravity of a trapezoidal dam section whose top width is a, bottom width is band the vertical side is a, from its vertical face is

Options:

A . None of these

B . (b² + bc + c²)/3 (b + c)

C . (a² + ab + b²)/3 (a + b)

D . (a² + ab + c²)/3 (a + c)

Answer: Option C

Submit Your Solution Below and Earn Points !

Next Question

Submit Solution

More Questions on This Topic :

Question 1. If the linear velocity of a point on the rim of a wheel of 10 m diameter, is 50 m/sec, its angular velocity will be....

Question 2. The masses of two balls are in the ratio of 2 : 1 and their respective velocities are in the ratio of 1 : 2 but in oppos....velocities of separation of the balls will be equal to

Question 3. A stone is thrown vertically upwards with a vertical velocity of 49 m/sec. It returns to the ground in....

Question 4. The unit of force in C.G.S. system of units, is called....

Question 5. Pick up the correct statement from the following. A rubber ball when strikes a wall rebounds but a lead ball of same mas....mass and velocity when strikes the same wall, falls down

Question 6. A string of length 90 cm is fastened to two points ‘A’ and ‘B’ at the same level 60 cm apart. A ring weighing 12....in equilibrium vertically below ‘B’. The value of ‘P’ is:

Question 7. If two forces of 3 kg and 4 kg act at right angles to each other, their resultant force will be equal to....

Question 8. A body of weight ‘w’ placed on an inclined plane is acted upon by a force ‘P’ parallel to the plane which causes....of friction is ‘φ’, the minimum value of ‘P’, is

Question 9. The resultant of the forces acting on a body will be zero if the body....

Question 10. The beam shown in below figure is supported by a hinge at ‘A’ and a roller at ‘B’. The reaction RA of the hinged....beam, is Applied Mechanics and Graphic Statics mcq question image

Chapter 1 - GLOBAL STEEL SCENARIO & INDIAN STEEL INDUSTRY Part 1 : (13-04-2024) INDUSTRY AND COMPANY AWARENESS (ICA)

Direction Sense Test Part 1 Reasoning (Hindi)

Chapter 1 - RMHP / OHP / OB & BP Part 1 : (14-02-2024) GPOE

Cube & Cuboid Part 1 Reasoning (Hindi)

Data Interpretation (DI) Basic Concept Reasoning (Hindi)

Counting Figures Part 1 Counting Of Straight Lines Reasoning (Hindi)

Sail E0 free webinar Webinars

Real Numbers Part 7 Class 10 Maths

Real Numbers Part 1 Class 10 Maths

Polynomials Part 1 Class 10 Maths

GPOE / GPA Combined 1 Free Mock Test SAIL JO E-0 2024

Chapter 3.1 : INTRODUCTION Chapter 3 : Sinter Plant SAIL E0 - GPOE/GPA 2024

Chapter 2.3 : COAL HANDLING PLANT - Set 1 Chapter 2 : Coke Ovens and Coal Chemicals SAIL E0 - GPOE/GPA 2024

Chapter 1.1 : INTRODUCTION Chapter 1 : Raw Material Handling Plant SAIL E0 - GPOE/GPA 2024

DSP Combined 1 Free Revision Test SAIL JO E-0