Normally the limiting value of cant is (where G is the gauge.)

Sail E0 Webinar

Question

Normally the limiting value of cant is (where G is the gauge.)

Options:

A . G/8

B . G/10

C . G/12

D . G/15

Answer: Option B

Submit Your Solution Below and Earn Points !

Next Question

Submit Solution

More Questions on This Topic :

Question 1. Tensile strength of steel used in rails should not be less than....

Question 2. Largest dimension of a rail is its....

Question 3. For the purpose of track maintenance, the number of turn out equivalent to one track km are....

Question 4. Due to battering action of wheels over the end of the rails, the rails get bent down and are deflected at ends. These ra....down and are deflected at ends. These rails are called

Question 5. Yellow lighthand signal indicates....

Question 6. Consider the following statements about concrete sleepers.1. They improve the track modulus.2. They have good scrap valu....easy.4. They maintain the gauge quite satisfactorily. Of these statements

Question 7. Consider the following statements:Automatic signalling system results in 1. greater risk 2. higher efficiency3. avoidanc....avoidance of block instruments4. higher operating cost Of these statements

Question 8. Minimum composite sleeper index pres-cried on Indian Railways for a track sleeper is....

Question 9. The distance through which the tongue rail moves laterally at the toe of the switch for movement of trains is called....

Question 10. The type of bearing plate used in all joints and on curves to give better bearing area to the rails is....

Chapter 1 - GLOBAL STEEL SCENARIO & INDIAN STEEL INDUSTRY Part 1 : (13-04-2024) INDUSTRY AND COMPANY AWARENESS (ICA)

Direction Sense Test Part 1 Reasoning (Hindi)

Chapter 1 - RMHP / OHP / OB & BP Part 1 : (14-02-2024) GPOE

Cube & Cuboid Part 1 Reasoning (Hindi)

Data Interpretation (DI) Basic Concept Reasoning (Hindi)

Counting Figures Part 1 Counting Of Straight Lines Reasoning (Hindi)

Sail E0 free webinar Webinars

Real Numbers Part 7 Class 10 Maths

Real Numbers Part 1 Class 10 Maths

Polynomials Part 1 Class 10 Maths

GPOE / GPA Combined 1 Free Mock Test SAIL JO E-0 2024

Chapter 3.1 : INTRODUCTION Chapter 3 : Sinter Plant SAIL E0 - GPOE/GPA 2024

Chapter 2.3 : COAL HANDLING PLANT - Set 1 Chapter 2 : Coke Ovens and Coal Chemicals SAIL E0 - GPOE/GPA 2024

Chapter 1.1 : INTRODUCTION Chapter 1 : Raw Material Handling Plant SAIL E0 - GPOE/GPA 2024

DSP Combined 1 Free Revision Test SAIL JO E-0