Newton-Rikhman law is given by

Sail E0 Webinar

Question

Newton-Rikhman law is given by

Options:

A . Q = h A (t s – t f)

B . Q = 2 h A (t s – t f)

C . Q = 3 h A (t s – t f)

D . Q = 4 h A (t s – t f)

Answer: Option A
Answer: (a).Q = h A (t s – t f)

Was this answer helpful ?

Next Question

Submit Solution

More Questions on This Topic :

Question 1. The convection coefficients for boiling and condensation lie in the range....

Question 2. Forced air flows over a convection heat exchanger in a room heater, resulting in a convective heat transfer coefficient ....exchanger surface area required for 8.8 k W of heating

Question 3. The value of film coefficient is dependent upon (i) Boundary layer configuration (ii) Geometry and orientation of the s....layer configuration (ii) Geometry and orientation of the surface (iii) Surface conditions

Question 4. A region of fluid motion near a plate in which temperature gradient exist is....

Question 5. Thermo-physical properties of the fluid are represented by (i) Density (ii) Viscosity (iii) Specific heat (iv) Thermal ....by (i) Density (ii) Viscosity (iii) Specific heat (iv) Thermal conductivity Identify the correct option

Question 6. Air at 20 degree Celsius flows over a flat surface maintained at 80 degree Celsius. The local heat flow at a point was m....the temperature at a distance 0.5 mm from the surface

Question 7. A motor cycle cylinder consists of ten fins, each 150 mm outside diameter and 75 mm inside diameter. The average fin tem....cycle is stationary and convective coefficient is 6 W/m² K

Question 8. For laminar flow over a flat plate, the average value of Nusselt number is prescribed by the relation Nu = 0.664 (Re)^0....(Re)^0.5 (Pr)^0.33 Which of the following is then a false statement?

Question 9. The convective heat transfer coefficient in laminar flow over a flat plate....

Question 10. For turbulent flow over a flat plate, the average value of Nusselt number is prescribed by the relation Nu = 0.664 (Re)....then a false statement? The average heat transfer coefficient increases as

Chapter 1 - GLOBAL STEEL SCENARIO & INDIAN STEEL INDUSTRY Part 1 : (13-04-2024) INDUSTRY AND COMPANY AWARENESS (ICA)

Direction Sense Test Part 1 Reasoning (Hindi)

Chapter 1 - RMHP / OHP / OB & BP Part 1 : (14-02-2024) GPOE

Cube & Cuboid Part 1 Reasoning (Hindi)

Data Interpretation (DI) Basic Concept Reasoning (Hindi)

Counting Figures Part 1 Counting Of Straight Lines Reasoning (Hindi)

Sail E0 free webinar Webinars

Real Numbers Part 7 Class 10 Maths

Real Numbers Part 1 Class 10 Maths

Polynomials Part 1 Class 10 Maths

GPOE / GPA Combined 1 Free Mock Test SAIL JO E-0 2024

Chapter 3.1 : INTRODUCTION Chapter 3 : Sinter Plant SAIL E0 - GPOE/GPA 2024

Chapter 2.3 : COAL HANDLING PLANT - Set 1 Chapter 2 : Coke Ovens and Coal Chemicals SAIL E0 - GPOE/GPA 2024

Chapter 1.1 : INTRODUCTION Chapter 1 : Raw Material Handling Plant SAIL E0 - GPOE/GPA 2024

DSP Combined 1 Free Revision Test SAIL JO E-0