In ultrasonic machining, the metal is removed by Options: A . &nbspUsing abrasive slurry between the tool and work B . &nbspDirect contact of tool with the work C . &nbspMaintaining an electrolyte between the work and tool in a very small gap between the two D . &nbspErosion caused by rapidly recurring spark discharges between the tool and work

In ultrasonic machining, the metal is removed by

Question

In ultrasonic machining, the metal is removed by

Options:

A . Using abrasive slurry between the tool and work

B . Direct contact of tool with the work

C . Maintaining an electrolyte between the work and tool in a very small gap between the two

D . Erosion caused by rapidly recurring spark discharges between the tool and work

Answer: Option A

Submit Your Solution Below and Earn Points !

Next Question

Question 1. The rear teeth of a broach....

Question 2. Crater wear leads to....

Question 3. Which of the following parameters influence the axial feed rate in centerless grinding?....

Question 4. A drill mainly used in drilling brass, copper or softer materials, is....

Question 5. A lead-screw with half nuts in a lathe, free to rotate in both directions has....

Question 6. The height of each tooth of a broach is....

Question 7. If the cutting speed is increased, then the built-up-edge....

Question 8. For softer materials, the point angle of the drill is kept....

Question 9. For harder alloy steel, the point angle of the drill is kept....

Question 10. The lathe spindles at the nose end have....

Chapter 1 - GLOBAL STEEL SCENARIO & INDIAN STEEL INDUSTRY Part 1 : (13-04-2024) INDUSTRY AND COMPANY AWARENESS (ICA)

Direction Sense Test Part 1 Reasoning (Hindi)

Chapter 1 - RMHP / OHP / OB & BP Part 1 : (14-02-2024) GPOE

Cube & Cuboid Part 1 Reasoning (Hindi)

Data Interpretation (DI) Basic Concept Reasoning (Hindi)

Counting Figures Part 1 Counting Of Straight Lines Reasoning (Hindi)

Sail E0 free webinar Webinars

Real Numbers Part 7 Class 10 Maths

Real Numbers Part 1 Class 10 Maths

Polynomials Part 1 Class 10 Maths

Pie Chart - Test Paper 1 Data Interpretation Reasoning & DI

Tabulation - Test Paper 2 Data Interpretation Reasoning & DI

Test Paper 1 Direction Sense Test Reasoning & DI

ICA , RDIC,GFM Free Modal Test Paper - Non - Technical Branch Old Syllabus 2022 - SAIL Junior Officer E0

GFM Combined 1 Free Revision Test SAIL JO E-0