Analysis of heat flow from the finned surface is made with the following assumpt

Sail E0 Webinar

Question

Analysis of heat flow from the finned surface is made with the following assumptions
(i) Uniform heat transfer coefficient, h over the entire fin surface
(ii) No heat generation within the fin generation
(iii) Homogenous material
Identify the correct option

Options:

A . i only

B . i and ii only

C . i, ii and iii

D . ii only

Answer: Option C
Answer: (c).i, ii and iii

Was this answer helpful ?

Next Question

Submit Solution

More Questions on This Topic :

Question 1. If heat conducted into the element at plane x is Q X = – k A C (d t/d x) X. Then heat conducted out of the element at ....of the element at plane (x + d x) is

Question 2. A heating unit is made in the form of a vertical tube of 50 mm outside diameter and 1.2 m height. The tube is fitted wit....the amount of heat transferred from the tube without fin

Question 3. In convection from the tip, we introduced a factor known as....

Question 4. For steady flow of heat along a rod, the general equation is d²α/dx² – m² α = 0 The value of constant....– m² α = 0 The value of constant m is

Question 5. In heat dissipation from an infinitely long fin, the boundary conditions are....

Question 6. Let us say there are two rods having same dimensions, one made of brass (k = 85W/m K) and the other of copper (k = 375W/....copper rod? Both ends are exposed to the same environment

Question 7. The temperature distribution in case of infinitely long fin is....

Question 8. The rate of heat transfer in case of infinitely long fin is given by....

Question 9. Three rods, one made of silver (l = 420W/m K), second made of aluminum (k = 210W/m K) and the third made of iron (k = 70....lengths up to which wax will melt on each rod

Question 10. A rod of 10 mm square section and 160 mm length with thermal conductivity of 50W/m K protrudes from a furnace wall at 20....calculations for the heat convective up to 80 mm length

Chapter 1 - GLOBAL STEEL SCENARIO & INDIAN STEEL INDUSTRY Part 1 : (13-04-2024) INDUSTRY AND COMPANY AWARENESS (ICA)

Direction Sense Test Part 1 Reasoning (Hindi)

Chapter 1 - RMHP / OHP / OB & BP Part 1 : (14-02-2024) GPOE

Cube & Cuboid Part 1 Reasoning (Hindi)

Data Interpretation (DI) Basic Concept Reasoning (Hindi)

Counting Figures Part 1 Counting Of Straight Lines Reasoning (Hindi)

Sail E0 free webinar Webinars

Real Numbers Part 7 Class 10 Maths

Real Numbers Part 1 Class 10 Maths

Polynomials Part 1 Class 10 Maths

Pie Chart - Test Paper 1 Data Interpretation Reasoning & DI

Tabulation - Test Paper 2 Data Interpretation Reasoning & DI

Test Paper 1 Direction Sense Test Reasoning & DI

ICA , RDIC,GFM Free Modal Test Paper - Non - Technical Branch Old Syllabus 2022 - SAIL Junior Officer E0

GFM Combined 1 Free Revision Test SAIL JO E-0