A stable process in any manufacturing process exhibits only ______ Options: A . &nbspAssignable causes of variations B . &nbspSpecial causes of variations C . &nbspChance cause of variations D . &nbspA stable process cannot be predicted

A stable process in any manufacturing process exhibits only _____

Question

A stable process in any manufacturing process exhibits only ______

Options:

A . Assignable causes of variations

B . Special causes of variations

C . Chance cause of variations

D . A stable process cannot be predicted

Answer: Option C
Answer: (c).Chance cause of variations

Was this answer helpful ?

Next Question

Question 1. Tolerance limits are the voice of the customer.....

Question 2. The upper specification limit of a product is 20.05 mm and the lower specification limit of the same product is 19.95 mm....What is the value of the process capability index Cₚ?

Question 3. What is the interpretation of Cₚₖ=Cₚ?....

Question 4. Natural tolerance is also known as _______....

Question 5. What is the interpretation of Cₚ>1?....

Question 6. The peak of a curve is located at (4,4). Four students located the peak of the curve to be at (3,4), (5,4), (4,3), and (....(4,5). What can be the conclusion made by this study?

Question 7. If the diameter of a shaft is measured as 80 mm, 81 mm, 82 mm, 83 mm, 84 mm, 85 mm. What is the median of the observed v....85 mm. What is the median of the observed values?

Question 8. If the diameter of a shaft is measured as 80 mm, 81 mm, 82 mm, 83 mm, 84 mm. What is the median of the observed values?....84 mm. What is the median of the observed values?

Question 9. The height of a tank measured by five engineers is 5 m, 4 m, 4.5 m , 4.5 m, 5 m. What is the mode of the calculated valu....5 m. What is the mode of the calculated values?

Question 10. If the observed diameter of a shaft is 20 mm, 21 mm, 23 mm, 22.5 mm, 24 mm. What is the mode of the observed data?....

Chapter 1 - GLOBAL STEEL SCENARIO & INDIAN STEEL INDUSTRY Part 1 : (13-04-2024) INDUSTRY AND COMPANY AWARENESS (ICA)

Direction Sense Test Part 1 Reasoning (Hindi)

Chapter 1 - RMHP / OHP / OB & BP Part 1 : (14-02-2024) GPOE

Cube & Cuboid Part 1 Reasoning (Hindi)

Data Interpretation (DI) Basic Concept Reasoning (Hindi)

Counting Figures Part 1 Counting Of Straight Lines Reasoning (Hindi)

Sail E0 free webinar Webinars

Real Numbers Part 7 Class 10 Maths

Real Numbers Part 1 Class 10 Maths

Polynomials Part 1 Class 10 Maths

Pie Chart - Test Paper 1 Data Interpretation Reasoning & DI

Tabulation - Test Paper 2 Data Interpretation Reasoning & DI

Test Paper 1 Direction Sense Test Reasoning & DI

ICA , RDIC,GFM Free Modal Test Paper - Non - Technical Branch Old Syllabus 2022 - SAIL Junior Officer E0

GFM Combined 1 Free Revision Test SAIL JO E-0