In a multiple V-belt drive, when a single belt is damaged, it is preferable to change the complete set in order to Options: A . &nbspReduce vibration B . &nbspReduce slip C . &nbspEnsure uniform loading D . &nbspEnsure proper alignment

In a multiple V-belt drive, when a single belt is damaged, it is preferable to c

Question

In a multiple V-belt drive, when a single belt is damaged, it is preferable to change the complete set in order to

Options:

A . Reduce vibration

B . Reduce slip

C . Ensure uniform loading

D . Ensure proper alignment

Answer: Option C

Submit Your Solution Below and Earn Points !

Next Question

Question 1. The allowable static stress for steel gears is approximately __________ of the ultimate tensile stress.....

Question 2. In a butt welded joint, the size of weld is __________ the throat of weld.....

Question 3. In a transverse fillet welded joint, the size of weld is __________ the throat of weld.....

Question 4. The radial distance of a tooth from the pitch circle to the top of the tooth is called....

Question 5. When the screw in a mechanical screw jack rotates, the load kept on the top of it moves....

Question 6. In a steam engine, the piston rod is usually connected to the cross-head by means of a....

Question 7. If a material fails below its yield point, failure would be due to....

Question 8. A sliding bearing which can support steady loads without any relative motion between the journal and the bearing, is cal....relative motion between the journal and the bearing, is called

Question 9. The backlash for spur gears depends upon....

Question 10. When an open coiled helical compression spring is subjected to an axial compressive load, the stress induced in the wire....axial compressive load, the stress induced in the wire is

Chapter 1 - GLOBAL STEEL SCENARIO & INDIAN STEEL INDUSTRY Part 1 : (13-04-2024) INDUSTRY AND COMPANY AWARENESS (ICA)

Direction Sense Test Part 1 Reasoning (Hindi)

Chapter 1 - RMHP / OHP / OB & BP Part 1 : (14-02-2024) GPOE

Cube & Cuboid Part 1 Reasoning (Hindi)

Data Interpretation (DI) Basic Concept Reasoning (Hindi)

Counting Figures Part 1 Counting Of Straight Lines Reasoning (Hindi)

Sail E0 free webinar Webinars

Real Numbers Part 7 Class 10 Maths

Real Numbers Part 1 Class 10 Maths

Polynomials Part 1 Class 10 Maths

Pie Chart - Test Paper 1 Data Interpretation Reasoning & DI

Tabulation - Test Paper 2 Data Interpretation Reasoning & DI

Test Paper 1 Direction Sense Test Reasoning & DI

ICA , RDIC,GFM Free Modal Test Paper - Non - Technical Branch Old Syllabus 2022 - SAIL Junior Officer E0

GFM Combined 1 Free Revision Test SAIL JO E-0