Sail E0 Webinar

MCQs

Total Questions : 2607 | Page 96 of 261 pages
Question 951.
 
The width of the pulley should be __________ width of the belt.
  1.    equal to
  2.    less than
  3.    greater than
 Discuss Question
Answer: Option C. -> greater than


Question 952.
The design of the pressure vessel is based on
  1.    longitudinal stress B.C. D.
  2.    hoop stress
  3.    longitudinal and hoop stress
  4.    none of these
 Discuss Question
Answer: Option B. -> hoop stress


Question 953.

A spring of
stiffness 1000 N/m is streteched initially by 100 mm from the undeformed
position. The work required to stretch it by another 100 mm is


  1.    5 N-m
  2.    7 N-m
  3.    10 N-m
  4.    15 N-m
 Discuss Question
Answer: Option D. -> 15 N-m


Question 954.

A feather key transmits a turning moment and permits axial movement also.


  1.    True
  2.    False
 Discuss Question
Answer: Option A. -> True


Question 955.
The steel pulleys are __________ in weight than cast iron pulleys of the same capacity.
  1.    heavier
  2.    lighter
 Discuss Question
Answer: Option B. -> lighter


Question 956.

The parallel fillet welded joints are designed for compressive strength.


  1.    Agree
  2.    Disagree
 Discuss Question
Answer: Option B. -> Disagree


Question 957.

In a multiple V-belt drive, if one of the belts break, then


  1.    only the broken belt is replaced
  2.    the entire set of belts is replaced
  3.    the broken belt and the belt on either side of it, is replaced
  4.    the broken belt need not to be replaced
 Discuss Question
Answer: Option B. -> the entire set of belts is replaced


Question 958.

The piston pin bearings in heavy duty diesel engines are


  1.    needle roller bearings
  2.    tapered rolierbearings
  3.    spherical roller bearings
  4.    cylindrical roller bearings
 Discuss Question
Answer: Option A. -> needle roller bearings


Question 959.

Cast iron pipes are mainly used


  1.    for conveying steam
  2.    in water and sewage systems
  3.    in pressure lubrication systems on prime movers
  4.    all of the above
 Discuss Question
Answer: Option B. -> in water and sewage systems


Question 960.
 
The bending stress in a curved beam is
  1.    zero at the centroidal axis
  2.    zero at the point other than centroidal axis
  3.    maximum at the neutral axis
  4.    none of these
 Discuss Question
Answer: Option B. -> zero at the point other than centroidal axis


Latest Videos

Latest Test Papers