Question 711. You have two switches connected together with two crossover cables for redundancy, and STP is disabled. Which of the following will happen between the switches?

Question 712. In which circumstance are multiple copies of the same unicast frame likely to be transmitted in a switched LAN?

Question 713. If you want to disable STP on a port connected to a server, which command would you use?

Question 714. Layer 2 switching provides which of the following?1. Hardware-based bridging (ASIC)2. Wire speed3. Low latency4. Low cost

Question 715. Your switch has a port status LED that is alternating between green and amber. What could this indicate?

Question 716. You want to run the new 802.1w on your switches. Which of the following would enable this protocol?

Question 717. Which of the following is a layer 2 protocol used to maintain a loop-free network?

Question 718. You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy?1. Switch (config-if) # ip access-group 102. Switch (config-if) # switchport port-security maximum 13. Switch (config) # access-list 10 permit ip host 14. Switch (config-if) # switchport port-security violation shutdown5. Switch (config) # mac-address-table secure

Question 719. What command will display the forward/filter table?

Question 720. If a switch receives a frame and the source MAC address is not in the MAC address table but the destination address is, what will the switch do with the frame?