Surface endurance limit of gear material is dependent upon its

Question

Surface endurance limit of gear material is dependent upon its

Options:

A . Elastic strength

B . Yield strength

C . Brinell hardness number

D . Toughness

Answer: Option C

Submit Your Solution Below and Earn Points !

Next Question

Submit Solution

More Questions on This Topic :

Question 1. The deflection of a cantilever beam under load W is 8. If its width is halved, then the deflection under load W will be....is halved, then the deflection under load W will be

Question 2. The initial tension (in newtons) in a bolt used for making a fluid tight joint like steam engine cover joints, is calcul....relation (where d = Nominal diameter of bolt in mm)

Question 3. According to Indian standards, total numbers of tolerance grades are....

Question 4. In order to avoid tearing of the plate at an edge, the distance from the centre line of the rivet hole to the nearest ed....be equal to (where d = Diameter of rivet hole)

Question 5. The ratio of circumferential stress to longitudinal stress in a thin cylinder subjected to an internal pressure is....

Question 6. The most important dimension in the design of a nut is....

Question 7. The value of Lewis form factor used in design of gears is....

Question 8. The design of the pressure vessel is based on....

Question 9. For crank shaft bearings, the ratio of the length of the journal to its diameter is_________.....

Question 10. The stress which vary from a minimum value to a maximum value of the same nature (i.e. tensile or compressive) is called....of the same nature (i.e. tensile or compressive) is called

Chapter 1 - GLOBAL STEEL SCENARIO & INDIAN STEEL INDUSTRY Part 1 : (13-04-2024) INDUSTRY AND COMPANY AWARENESS (ICA)

Direction Sense Test Part 1 Reasoning (Hindi)

Chapter 1 - RMHP / OHP / OB & BP Part 1 : (14-02-2024) GPOE

Cube & Cuboid Part 1 Reasoning (Hindi)

Data Interpretation (DI) Basic Concept Reasoning (Hindi)

Counting Figures Part 1 Counting Of Straight Lines Reasoning (Hindi)

Sail E0 free webinar Webinars

Real Numbers Part 7 Class 10 Maths

Real Numbers Part 1 Class 10 Maths

Polynomials Part 1 Class 10 Maths

Chapter 3.1 : Overview of Finance & Accounts Department Chapter 3 : Finance & Accounts SAIL E0 - GFM 2024

Chapter 2.1 : Overview Chapter 2 : Materials Management SAIL E0 - GFM 2024

Chapter 1.1 : Personnel Functions- An overview Chapter 1 : Personnel Management SAIL E0 - GFM 2024

GPOE / GPA Combined 1 Free CBT Mock Test SAIL E0 2024

CBT Mixed Test 1 GPOE/GPA SAIL E0 2024