Sail E0 Webinar

MCQs

Total Questions : 50 | Page 1 of 5 pages
Question 1. A low ratio of the ac to the dc load impedance of a diode detector results in
  1.    Diagonal clipping
  2.    Poor AGC operation
  3.    Negative-peak clipping
  4.    Poor AF response
 Discuss Question
Answer: Option C. -> Negative-peak clipping
Question 2. Indicate which of the following circuits could not demodulate SSB:
  1.    Balance modulator
  2.    Product modulator
  3.    BFO
  4.    Phase discriminator
 Discuss Question
Answer: Option D. -> Phase discriminator
Question 3. If the intermediate frequency is very high (indicate false statement)
  1.    Image frequency rejection is very good
  2.    The local oscillator need not be extremely stable
  3.    The selectivity will be poor
  4.    Tracking will be improved
 Discuss Question
Answer: Option D. -> Tracking will be improved
Question 4. One of the following cannot be used to demodulate SSB:
  1.    Product detector
  2.    Diode Balance modulator
  3.    Bipolar transistor balanced modulator
  4.    Complete phase-shift generator
 Discuss Question
Answer: Option C. -> Bipolar transistor balanced modulator
Question 5. Indicate which of the following statements about the advantages of the phase discriminator over the slope detector is false:
  1.    Much easier alignment
  2.    Better linearity
  3.    Greater limiting
  4.    Fewer tuned circuits
 Discuss Question
Answer: Option C. -> Greater limiting
Question 6. The controlled oscillator synthesizer is sometimes preferred over the direct one because
  1.    It is a simpler piece of equipment
  2.    Its frequency stability is better
  3.    It does not require crystal oscillator
  4.    It is relatively free of spurious frequency
 Discuss Question
Answer: Option D. -> It is relatively free of spurious frequency
Question 7. A superheterodyne receiver with an IF of 450 kHz is tuned to a signal at 1200 kHz. The image frequency is
  1.    750 kHz
  2.    900 kHz
  3.    1650 kHz
  4.    2100 kHz
 Discuss Question
Answer: Option D. -> 2100 kHz
Question 8. The local oscillator of a broadcast receiver is tuned to a frequency higher than the incoming frequency
  1.    To help the image frequency rejection
  2.    To permit easier tracking
  3.    Because otherwise an intermediate frequency could not be produced
  4.    To allow adequate frequency coverage without switching
 Discuss Question
Answer: Option D. -> To allow adequate frequency coverage without switching
Question 9. Show which of the following statements about the amplitude limiter is untrue:
  1.    The circuit is always biased in class C, by virtue of the leak-type bias.
  2.    When the input increases past the threshold of the limiting, the gain decreases to keep the output constant.
  3.    The output must be tuned
  4.    Leak-type bias must be used
 Discuss Question
Answer: Option A. -> The circuit is always biased in class C, by virtue of the leak-type bias.
Question 10. A receiver has poor IF selectivity. It will therefore also have poor
  1.    Blocking
  2.    Double-spotting
  3.    Diversion reception
  4.    Sensitivity
 Discuss Question
Answer: Option A. -> Blocking

Latest Videos
Chapter 1 - GLOBAL STEEL SCENARIO & INDIAN STEEL INDUSTRY Part 1 : (13-04-2024) INDUSTRY AND COMPANY AWARENESS (ICA)
Direction Sense Test Part 1 Reasoning (Hindi)
Chapter 1 - RMHP / OHP / OB & BP Part 1 : (14-02-2024) GPOE
Cube & Cuboid Part 1 Reasoning (Hindi)
Data Interpretation (DI) Basic Concept Reasoning (Hindi)
Counting Figures Part 1 Counting Of Straight Lines Reasoning (Hindi)
Sail E0 free webinar Webinars
Real Numbers Part 7 Class 10 Maths
Real Numbers Part 1 Class 10 Maths
Polynomials Part 1 Class 10 Maths

Latest Test Papers

Pie Chart - Test Paper 1 Data Interpretation Reasoning & DI
Tabulation - Test Paper 2 Data Interpretation Reasoning & DI
Test Paper 1 Direction Sense Test Reasoning & DI
ICA , RDIC,GFM Free Modal Test Paper - Non - Technical Branch Old Syllabus 2022 - SAIL Junior Officer E0
GFM Combined 1 Free Revision Test SAIL JO E-0