Sail E0 Webinar

Computer Aptitude > Networking

NETWORK ADDRESS TRANSLATION MCQs

Total Questions : 37 | Page 1 of 4 pages
Question 1. Which command would you place on interface connected to the Internet?
  1.    ip nat inside
  2.    ip nat outside
  3.    ip outside global
  4.    ip inside local
 Discuss Question
Answer: Option B. -> ip nat outside
Question 2. Which command will show you all the translations active on your router?
  1.    show ip nat translations
  2.    show ip nat statistics
  3.    debug ip nat
  4.    clear ip nat translations *
 Discuss Question
Answer: Option A. -> show ip nat translations
Question 3. Which command would you place on interface on a private network?
  1.    ip nat inside
  2.    ip nat outside
  3.    ip outside global
  4.    ip inside local
 Discuss Question
Answer: Option A. -> ip nat inside
Question 4. Pat Address Translation is also termed what?
  1.    NAT Fast
  2.    NAT Static
  3.    NAT Overload
  4.    Overloading Static
 Discuss Question
Answer: Option C. -> NAT Overload
Question 5. When creating a pool of global addresses, which of the following can be used instead of the netmask command?
  1.    / (slash notation)
  2.    prefix-length
  3.    no mask
  4.    block-size
 Discuss Question
Answer: Option B. -> prefix-length
Question 6. Which of the following would be a good starting point for troubleshooting if your router is not translating?
  1.    Reboot.
  2.    Call Cisco.
  3.    Check your interfaces for the correct configuration.
  4.    Run the debug all command.
 Discuss Question
Answer: Option C. -> Check your interfaces for the correct configuration.
Question 7. Which command will show you the summary of the NAT configuration?
  1.    show ip nat translations
  2.    show ip nat statistics
  3.    debug ip nat
  4.    clear ip nat translations *
 Discuss Question
Answer: Option B. -> show ip nat statistics
Question 8. Which of the following is considered to be the destination host before translation?
  1.    Inside local
  2.    Outside local
  3.    Inside global
  4.    Outside global
 Discuss Question
Answer: Option B. -> Outside local
Question 9. Which are considered the methods of NAT?
1. Static
2. IP NAT pool
3. Dynamic
4. NAT double-translation
5. Overload
  1.    1 and 6
  2.    3 only
  3.    1, 3 and 5
  4.    All of the above
 Discuss Question
Answer: Option C. -> 1, 3 and 5
Question 10. Which command will allow you to see real-time translations on your router?
  1.    show ip nat translations
  2.    show ip nat statistics
  3.    debug ip nat
  4.    clear ip nat translations *
 Discuss Question
Answer: Option C. -> debug ip nat

Latest Videos

Latest Test Papers