Sail E0 Webinar

MCQs

Total Questions : 90 | Page 2 of 9 pages
Question 11. Determine the velocity of flow in a pipe if the discharge capacity is 270 litres per second and cross sectional area is 5 cm².
  1.    4.5 m/s
  2.    5.4 m/s
  3.    3.4 m/s
  4.    2.5 m/s
 Discuss Question
Answer: Option B. -> 5.4 m/s
Answer: (b).5.4 m/s
Question 12. Calculate the reaction at prop of cantilever, if the span of beam is 5m and load is 20 kN.
  1.    4.25 kN
  2.    5 kN
  3.    6.25 kN
  4.    8 kN
 Discuss Question
Answer: Option C. -> 6.25 kN
Answer: (c).6.25 kN
Question 13. The highest point on syphon is known as ____
  1.    Summit
  2.    Crown
  3.    Limb
  4.    Tread
 Discuss Question
Answer: Option A. -> Summit
Answer: (a).Summit
Question 14. Full form of TEL is _________
  1.    Total Emission Line
  2.    Thermal Electro Light
  3.    Total Energy Line
  4.    Total Electro Light
 Discuss Question
Answer: Option C. -> Total Energy Line
Answer: (c).Total Energy Line
Question 15. The position between the summit and the lower reservoir is known as ___________
  1.    Inlet leg
  2.    Outlet leg
  3.    Pressure head
  4.    Datum
 Discuss Question
Answer: Option B. -> Outlet leg
Answer: (b).Outlet leg
Question 16. ______ curves are used to solve the problems of land acquisition.
  1.    Vertical curves
  2.    Horizontal curves
  3.    Circular curves
  4.    Transition curves
 Discuss Question
Answer: Option B. -> Horizontal curves
Answer: (b).Horizontal curves
Question 17. The limiting gradient for mountainous terrain is ________
  1.    6.00 %
  2.    7.00 %
  3.    8.00 %
  4.    5.00 %
 Discuss Question
Answer: Option A. -> 6.00 %
Answer: (a).6.00 %
Question 18. Which of the following do not have units?
  1.    Specific weight
  2.    Specific gravity
  3.    Specific volume
  4.    Mass density
 Discuss Question
Answer: Option B. -> Specific gravity
Answer: (b).Specific gravity
Question 19. _____ is a glacier deposit of sand, gravel or clay.
  1.    Till
  2.    Tull
  3.    Loess
  4.    Mart
 Discuss Question
Answer: Option A. -> Till
Answer: (a).Till
Question 20. In engineering properties of soils, the “e” denotes?
  1.    Compressibility
  2.    Water content
  3.    Porosity
  4.    Voids ratio
 Discuss Question
Answer: Option D. -> Voids ratio
Answer: (d).Voids ratio

Latest Videos

Latest Test Papers