Sail E0 Webinar

MCQs

Total Questions : 540 | Page 5 of 54 pages
Question 41. These types of pipes are generally connected with bell and spigot joints or flanged joints:
  1.     Soil and waste
  2.     Water and gas
  3.     Water and steam
  4.     Gas and soil
 Discuss Question
Answer: Option B. ->  Water and gas
Question 42. Using the relative polar coordinate system to add a 3 inch line that is 45 degrees from the end point of the line created above the drafter would ________.
  1.     Type @3
  2.     Type 3 back slash and enter
  3.     Type 3 forward slash and enter
  4.     Type 3 and try to use the Dynamic Input readout to find the end point
 Discuss Question
Answer: Option A. ->  Type @3
Question 43. In this type of view, the cutting plane line indicates both the location of the cutting plane and the direction of sight:
  1.     Removed section
  2.     Revolved section
  3.     Auxiliary section
  4.     Partial section
 Discuss Question
Answer: Option C. ->  Auxiliary section
Question 44. The press-pull tool will ________ the face of a solid model in the direction it faces.
  1.     Taper
  2.     Extrude
  3.     Spiral
  4.     None of the above
 Discuss Question
Answer: Option B. ->  Extrude
Question 45. This is formed where three or more surfaces intersect:
  1.     Oblique
  2.     Line
  3.     Edge
  4.     Vertex
 Discuss Question
Answer: Option D. ->  Vertex
Question 46. The site plan illustrates _________.
  1.     The floor plan
  2.     Where the house sits on the property
  3.     The roof plan
  4.     Where the garage and driveway are located
 Discuss Question
Answer: Option B. ->  Where the house sits on the property
Question 47. An accurate record of changes made to release drawings is tracked via this:
  1.     A revision block
  2.     The basic title form
  3.     Working drawings
  4.     Portable documents
 Discuss Question
Answer: Option A. ->  A revision block
Question 48. This is the range of digital or hard copy documents that specify the physical function requirements for a product:
  1.     Product design
  2.     Product definition
  3.     Drawing definition
  4.     Engineering design
 Discuss Question
Answer: Option B. ->  Product definition
Question 49. In some circumstances an entire drawing can be inserted into a different drawing as a block. when this is used the base point will default to _________.
  1.     0, 0
  2.     10, 10
  3.     20, 20
  4.     30, 30
 Discuss Question
Answer: Option A. ->  0, 0
Question 50. This practice considers an individual part's dimensions and tolerances and that part's relation to its related parts:
  1.     Applying allowances
  2.     Geometric dimensioning and tolerancing
  3.     Creating datum references
  4.     Angular dimensioning tolerances
 Discuss Question
Answer: Option B. ->  Geometric dimensioning and tolerancing

Latest Videos

Latest Test Papers