Assertion A : For eccentricity ratio exceeding 1/6, effective thickness of mason

Sail E0 Webinar

Question

Assertion A : For eccentricity ratio exceeding 1/6, effective thickness of masonry will get reduced.Reason R : For eccentricity ratio exceeding 1/6, there will be tension on one side of the member. Select your answer according to the codes give below:

Options:

A . Both A and R is true and R is the correct explanation of A

B . Both A and R is true and R is not the correct explanation of A

C . A is true but R is false

D . A is false but R is true

Answer: Option A

Submit Your Solution Below and Earn Points !

Next Question

Submit Solution

More Questions on This Topic :

Question 1. Consider the following statements regarding bands to be provided for strengthening masonry work in masonry buildings con....of reinforced concrete only.of these statements, the correct statements are

Question 2. Consider the following statements regarding provision of chases in masonry,(i) No chase should be permitted in a half br....should be provided near to bearings of beams and lintels.

Question 3. The basic stress in masonry units having height to width ratio of 1.5 may be increased by a factor of....

Question 4. Minimum compressive strength in N/mm² for H1 type mortar used for masonry is....

Question 5. For designing masonry components of a structure, seismic forces provision in the design calculation is not necessary for....the design calculation is not necessary for buildings constructed in

Question 6. A 200 mm thick wall made of modular bricks is 5 m long between cross walls and 3.8 m clear height between RCC slabs at t....top and bottom. The slenderness ratio of the wall is

Question 7. In a cavity wall, both leaves of which are load bearing, the effective thickness is taken as....

Question 8. The mode of failure of a very short masonry member having h/t ratio of less than 4 is by....

Question 9. If the ratio of center to center spacing of intersecting walls to actual thickness of intersecting wall is more than 20,....20, then the stiffening coefficient for wall proper will be

Question 10. Where a structural component or a system is providing lateral support to five or more walls or columns, the lateral load....the most heavily loaded wall or column in the group

Chapter 1 - GLOBAL STEEL SCENARIO & INDIAN STEEL INDUSTRY Part 1 : (13-04-2024) INDUSTRY AND COMPANY AWARENESS (ICA)

Direction Sense Test Part 1 Reasoning (Hindi)

Chapter 1 - RMHP / OHP / OB & BP Part 1 : (14-02-2024) GPOE

Cube & Cuboid Part 1 Reasoning (Hindi)

Data Interpretation (DI) Basic Concept Reasoning (Hindi)

Counting Figures Part 1 Counting Of Straight Lines Reasoning (Hindi)

Sail E0 free webinar Webinars

Real Numbers Part 7 Class 10 Maths

Real Numbers Part 1 Class 10 Maths

Polynomials Part 1 Class 10 Maths

Pie Chart - Test Paper 1 Data Interpretation Reasoning & DI

Tabulation - Test Paper 2 Data Interpretation Reasoning & DI

Test Paper 1 Direction Sense Test Reasoning & DI

ICA , RDIC,GFM Free Modal Test Paper - Non - Technical Branch Old Syllabus 2022 - SAIL Junior Officer E0

GFM Combined 1 Free Revision Test SAIL JO E-0